Advertisement
CONNECTING LOUDSPEAKERS TO YOUR POWER AMPLIFIER
It is very simple to connect the loudspeakers to the amplifier, but the cable that connects the
loudspeakers with the amplifier can have a significant effect on the overall sound quality of your
audio system. So please choose high quality loudspeaker cables that can match your audio equipment
perfectly, ask your AURUM CANTUS dealer or distributor for their recommendation.
LEISURE 2 SE MKⅡ loudspeakers have two connectors on the rear panel. And each
accept spade plugs, banana plugs or bares wire.
Make sure the output terminals "+"or"red"
or " red" on the loudspeakers, likewise, make sure the output terminals "－" or " black" on the amplifier
are connected to the connectors"－"or"black"on the loudspeakers, and then please double check the
connections are correct and stable.
：
NOTE
BEFORE P
OWER UP, YOU MUST REMOVE THE PROTECTIVE MEMBRANE FROM
THE ALUMINUM RIBBON TWEETER.
THE OPERATION APPROACHES POWER UP
Firstly, switch on the power of the sound source equipment
ect) ,then switch on the power source of the amplifier (you must assure that the volume control of
the amplifier is set in the lowest (0) position)，lastly raise the output power of the amplifier slowly
after you inserted the software into the sound source equipment until you are satisfied with the
volume.
When yo
u want to shut down the audio system, please firstly dial the volume to the lowest (0)
position, and then switch off the power source of the amplifier, lastly switch off the power of the
sound source
equipment.
Please adjust the volume w
level is too strong, the instant peak value of the dynamic music may cause the amplifier to distor
and can cause damage to the loudspeakers.
If you purchased a low-priced amplifier, plea
LOUDSPEAKERS BREAK IN PERIOD
After testing, the pure aluminum ribbon loudspeaker
normal working condition. In order to achieve the optimum performance sooner, we recommend the
loudspeakers break in as continuously as possible.
CLEANING YOUR LOUDSPEAKERS
Please do remember not to use a vacuum cleane
cause damage to the diaphragm of the aluminum ribbon tweeter.
Please remove the grille before cleaning the grille cloth.
Use a damp soft cloth to clean the cabinets. We recommen
grade wax and polish the wood surface of the cabinet.
ATTENTION
The magnetic
field of the aluminum ribbon tweeter is very powerful, so please keep any
magnetizer away from the front plate of the loudspeaker at least 20cm/8" to avoid loudspe
damage due to the strong magnetic attraction.
Placing the loudspeaker near a television may c
about 90cm/35" away from your television when you combine your loudspeakers with a home
theater system.
on the amplifier are connected to the connectors "+"
ith care when you are playing dynamic music. If the sound pressure
se use it with care.
ause a magnetic interference. Place the speaker
(CD, SACD, DVD－Audio, LP, DVD
requires at least 80 hours of break in to obtain the
r on or near the loudspeakers, otherwise it could
d maintaining an occasional furniture
connector can
t
aker
3
Advertisement
