Macros (Sequence Of Commands Within A Certain Mode) - One for All URC-8350 Instruction Manual

Macros (Sequence of commands within a certain mode)

Within a certain device mode you can program your URC-8350 to issue a
sequence of commands at the press of one key.
Example: To program a macro on the LAST key to go to "AV" mode (in TV
mode) then to channel 801 of your Set-Top-Box.
1.
2.
3.
4.
5.
6.
Result: In TV mode, when you press and hold the LAST key the URC-8350 will
send commands to go in "AV" mode then switch to STB mode and go to
channel 801 of your Set-Top-Box.
- If you need to build in some delay into the sequence please use the
corresponding device-mode key (e.g. STB key in example above) to do so.
You may press this key several times to build in more delay.
- Each MACRO can consist of a maximum of 32 key strokes.
- Make sure that you program a Macro on a spare key, as the Macro will
overwrite the pre-programmed function in the mode where the Macro is
programmed.
- If you had to hold down a key for a few seconds on the original remote
control to get a function, this function may not work in a macro on your
URC-8350 remote.
Erasing the Macro
Example: To erase the Macro from the LAST key in STB mode, press:
1.
2.
3.
4.
5.
WWW.ONEFORALL.COM
Extra Features
Press and release TV key to select the mode where you
want to execute the macro.
Press and hold down REWIND + FASTFORWARD
simultaneously until the URC-8350's LED (red light)
blinks twice (the LED will blink once and then twice).
Press 9 9 5. The LED will blink twice.
Then press the LAST key (to which the Macro will be
assigned).
Next press TV then AV then STB then 8 0 1 to select the
desired channel on your Set-Top-Box.
To store the Macro, press and hold the OK key until the
LED will blink twice.
Press and release the device key (e.g. STB key) to select the
mode where
the macro is stored.
Press and hold down REWIND + FASTFORWARD
simultaneously until the URC-8350's LED (red light)
blinks twice (the LED will blink once and then twice).
Press 9 9 5. The LED will blink twice.
Press the LAST key (from which you want to erase the
macro).
To clear the Macro, press and hold the OK key until the
LED will blink twice.
9