Summary of Contents for Fortuna Electronic NaView GPS-610B
- Page 1 NaView GPS-610B Quick User Guide Fortuna Electronic Corp. 5F-2, No.23, Sec.1, ChangAn East Rd., Taipei, Taiwan Document No. : Issue Date : 2006/10/12...
-
Page 2: Front Components
Front Components Battery Charge The loading display will shine red during Indicator the charging process. It will shine green when the accumulator is completely charged. SD/MMC Slot Accepts an optional SD (Secure Digital) or MMC (MultiMedia Card) card for removable storage. Loudspeaker Plays back music, language statements and warnings. -
Page 3: Back Components
Back Components External Connection for an optional second aerial. aerial connection Battery The rechargeable battery inside. compartment Audio out Separates the device from the battery connector completely (also Hard Reset). Car adaptor Connection to Power cable for output 5V port / cigarette lighter. -
Page 4: Initial Setup
Initial Set-up The following guides you step by step through the initial set up of the navigation system. Firstly, remove the foil for protecting the device during transpor tation from the display. I. Charging the battery Attention: It can be necessary to recharge the battery for some time initially before it is possible to run through the initial installation, according to the state of charging of the battery installed. -
Page 5: Switching On The Navigation System
II. Switching on the navigation system 1. Take the pen out of its compartment and switch the main switch on the back of the device to ON. Attention: Always leave the main switch in the ON Position, unless you want to carry out a new reinstallation. All data will be lost and the initial installation will have to be carried out again if the switch is set to OFF. -
Page 6: Installing The Navigation Software
III. Installing the Navigation software You will be requested to install the Navigation Software during the initial installation. Please proceed as follows: Carefully take the memory card out of its packing. Take care not to touch or dirty the contacts. Push the memory card carefully into the SD-/MMC card bay until it slightly lock in place. - Page 7 I. Mounting the car holder Attention! Only fix the holder for the navigation system to the windscreen, if it does not impede the view. Should this not be possible, then mount the holder with the enclosed suction plate in any way that will allow peril-free and safe operation.
- Page 8 Note: To obtain a strong and secure hold the suction plate should not be used for 24 hours. II. F IXING THE SUCTION PLATE Note: Clean the disk thoroughly with a glass cleaner. Warm the disk and the nipple slightly at temperatures below 15°...
-
Page 9: Connecting The Car Adapter
Connecting the car adapter (similar picture) Plug the jack (1) of the connection cable into the corre- sponding receptor at the rear side of your navigation system. Insert the power adapter (2) now into the cigarette lighter socket and ensure, that it will not lose contact while driving. This could cause a malfunction. - Page 10 Federal Communications Commission (FCC) Statement 15.21 You are cautioned that changes or modifications not expressly approved by the part responsible for compliance could void the user’s authority to operate the equipment. 15.105(b) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules.
Need help?
Do you have a question about the NaView GPS-610B and is the answer not in the manual?
Questions and answers