Ipod/bluetooth 2nd receiver kit for home/car use (12 pages)
Summary of Contents for Scosche BTRH
Page 1
BTRH Bluetooth audio receiver User’s manual Content Brief introduction …………………………………………….…..….1 1. Bluetooth wireless communication technology………….……………1 2. About BTRH………………………………………………………..…1 Basic operation …………………………………………………..…..1 Overview …………………………………………………...…...………1 2. The steps of operation………………….…………………….…………2 3. Paired with Bluetooth device……………………………………...……2 1) How to enter paired mode…………………………………………...….2 2) Pairing with Bluetooth phone……………………………………….….2 3) Pairing with Bluetooth transmitter………………………………..…...3...
Welcome to use this Bluetooth audio receiver BTRH. Please read this user’s manual carefully before use. Brief introduction 1. Bluetooth wireless communication technology Bluetooth is a standard of close range wireless communication technology that was drawn up by Ericsson, IBM, Intel, Nokia and Toshiba in May, 1998.
Remarks: The pairing mode will last 2 minutes, BTRH will switch to standby mode automatically, if no devices can be connected after 2 minutes 2) Pairing with Bluetooth phone Prior to using the receiver for the first time, you have to pair it with a Bluetooth phone.
If the phone and receiver over range, the receiver will disconnect and enter standby mode. It will connect automatically if phone and receiver back to available range in 5 minutes. You also can select BTRH on the phone after 5 minutes.
Care and maintenance Read the following recommendations carefully before using BTRH. Following these you will be able to enjoy this product for many years. Keep it dry and don’t put it in moist place to avoid the product’s internal circuit being affected.
FAQs 1. Why the receiver can not paired with phone? Please make sure the receiver is in pairing mode. The pairing mode will last 2 minutes, it will enter standby mode automatically if overtime. Disconnect the receiver and socket, and reconnect them, after the receiver turned on, it will enter pairing mode automatically.
Page 7
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: - Reorient or relocate the receiving antenna.
Page 8
cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada.
Need help?
Do you have a question about the BTRH and is the answer not in the manual?
Questions and answers