Do you have a question about the MobileCam/Light Pro and is the answer not in the manual?
Questions and answers
Subscribe to Our Youtube Channel
Summary of Contents for SIIG MobileCam/Light Pro
Page 1
MobileCam/Light Pro Quick Installation Guide System Requirements Pentium-class notebook or desktop computer • with an available USB port Windows 98SE/ME/2000/XP/Server 2003 • Package Contents • MobileCam/Light Pro • USB extension cable (3ft.) • Driver/Utility CD • This quick installation guide...
Page 2
Figure 1. MobileCam/Light Pro Layout MobileCam/Light Pro Buttons • On/Off Light Button: Press the button on the back of the MobileCam/Light Pro to activate/ deactivate the light. • Snapshot Button: Press the button on the side of the MobileCam/Light Pro to take a snapshot.
Software Installation Important: Make sure the driver is installed before connecting the MobileCam/Light Pro to the USB port. Driver Installation Boot up to Windows and insert the driver CD. Click Start, Run. Type D:\Setup.exe, click OK. (Change D: to match your CD-ROM drive letter)
Page 4
Wizard, select Automatic search for a better driver (Recommended), click Next, then click Finish. Restart Windows to complete the installation. Windows 2000 Windows 2000 will automatically detect and install the correct driver for the MobileCam/Light Pro. Restart Windows if prompted.
Page 5
Windows XP/Server 2003 Plug the MobileCam/Light Pro into an available USB port. At the Found New Hardware Wizard. For XP: Select Install the software automatically (Recommended), then click Next. For XP wSP1 or later/Server 2003: Select No,not this time, then click Next. Select Install the software automatically (Recommended), then click Next.
Page 6
Double click Imaging Device(s) option and USB PC Camera with Mic... should be displayed. Sound The MobileCam/Light Pro comes with a built-in microphone. If you need this function, use the directions in this section to configure the microphone's recording level.
Page 7
In Sound Recording, select USB Audio Device as the preferred device. Click Volume, move the slider bar up to increase the recording level. Close the open windows when finished. Windows XP/Server 2003 In Control Panel, double click Sounds and Audio Devices, then click Audio tab. In Sound recording, select PC Camera as the preferred device.
Page 8
Important: On your very first time capturing video, click File, select Set capture file..., type in a file name with .avi extension, click Open, then click OK. An example for this file name is test.avi. You only have to do this once.
Page 9
Windows XP/Server 2003 Click the Snapshot button to start AMCAP. Important: On your very first time capturing video, click File, select Set capture file..., type in a file name with .avi extension, click Open, then click OK. An example for this file name is test.avi.
Page 10
Snapshot capture Windows 98SE/ME/2000 Click Start, Programs, USB PC Camera Plus, then AMCAP. Wait for an image to appear then click the Snapshot button. In the USB PC Camera with Mic window, click File, Save As, type in a name, then click Save. Windows XP/Server 2003 Click the Snapshot button to start AMCAP.
Page 11
CD-ROM:\Ulead Photo Explorer7.0SE Platinum \Document\Manual folder of the software CD. Please note that this utility is optional and not needed for the MobileCam/Light Pro to operate. Boot up to Windows and insert the driver CD. Click Start, Run. Type in D:\Ulead\setup.exe, then click OK.
Need help?
Do you have a question about the MobileCam/Light Pro and is the answer not in the manual?
Questions and answers