Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Access security product RD-SR2
- Page 1 RD-SR2 Proximity Card Reader with Remote Control User Manual...
-
Page 2: Specifications
INTRODUCTION The RD-SR2 is a compact, weather resistant multi-function card reader that can be used as a standalone programmable access control card reader as well as a Wiegand output card reader providing proximity entry for up to 1000 users, (998 common users and 2 panic users) PIN access is also possible via the remote control... -
Page 3: Package Contents
Package Contents SR2 Card Reader Infrared Remote Control Manager Cards Diode IN4004 (For relay circuit protection) Self Tapping Screws: 3*25mm Wall Anchors Screw Driver... -
Page 4: Installation
INSTALLATION Remove the back cover from the unit Drill 2 holes(A,C) on the wall for the screws and one hole for the cable Knock the supplied rubber bungs to the screw holes(A,C) Fix the back cover firmly on the wall with 4 flat head screws ... -
Page 5: Connection Diagram Examples
Connection Diagram Examples Common power supply for magnetic lock (Fail open – power to lock) Common power supply for lock release (Fail secure – power to unlock) Common power supply for auto gate controller (using Normally Open contact) Attention: Install a 1N4004 or equivalent diode across the locking device when using a common power supply to prevent any back E.M.F as the reader might damage. - Page 6 Connection to standard Wiegand controller or PC access control system Set Operation Mode – Stand-alone or Wiegand (Default is stand-alone) Programming Step Remote Control Operation 1. Enter Program Mode * (Master Code) # 2. Stand-alone Operation 72 # is factory default for stand-alone 73 # 3.
- Page 7 PROGRAMMING Programming will vary depending on access confirguration. Follow the instructions according to your access configuration General Programming Information – Two ways Remote Control: Please use the Infrared Remote Control to program the Reader. The infrared receiver head is near the LED, so when you program the reader, please direct the Remote Control to the LED User ID number: Assign a user ID to the access card in order to track it.
- Page 8 Set User Data Transfer Via the Remote Control Programming Step Remote Control Operation 1. Enter Program Mode * (Master Code) # 2. Set Transfer Data on the first SR2 96 # For all 1000 users, this will take 3 minutes Within 3 minutes the green LED will shine, after 1 x bleep the LED will turn red to confirm data transfer...
- Page 9 Delete All Users Via the Remote Control Programming Step Remote Control Operation 1. Enter Program Mode * (Master Code) # 2. Delete All User Cards 2 (Master Code) # 3. Exit Program Mode Set Relay Configuration Via the Remote Control The relay configuration sets the behaviour of the output relay on activation Programming Step Remote Control Operation...
-
Page 10: Reset Procedure
Set Card Reading Type Via the Remote Control Programming Step Remote Control Operation 1. Enter Program Mode * (Master Code) # 2. Read EM & HID card 93 # (factory default) 3. Read EM card only 94 # 95 # 4.
Need help?
Do you have a question about the RD-SR2 and is the answer not in the manual?
Questions and answers