Advertisement
Quick Links
9512- Trapezoidal Work Surface
Assembly Instructions
TRAPEZOIDAL SURFACE
1x
BAG A
BAG B
BAG C
4x
4x
4x
Table Bracket
M6 X 20mm
M6 x 16mm
BAG D
TOOLS INCLUDED
1x
1x
1x
1x
1x
Button Support
4mm Allen Wrench
Button
Nut
Plug
Bracket
1
For Customer Service Call:
Page
of 4
(800) 433-6614
www.viaseating.com
Advertisement
Summary of Contents for Legola 9512
- Page 1 9512- Trapezoidal Work Surface Assembly Instructions TRAPEZOIDAL SURFACE BAG A BAG B BAG C Table Bracket M6 X 20mm M6 x 16mm BAG D TOOLS INCLUDED Button Support 4mm Allen Wrench Button Plug Bracket For Customer Service Call: Page of 4 (800) 433-6614 www.viaseating.com...
- Page 2 1. Connect all panels using metal brackets (sold separately) as shown. *see General Panel Assembly Instructions 2. Connect Table Brackets (BAG A) to curved panels using long 20mm screws (BAG B) with allen wrench (included). NOTE: Some buttons may come fully assembled.
- Page 3 4. Slide Button with Support Bracket attached into Panel slots with FLUSH SIDE FACING UP. 5. Slide the Trapezoidal Shelf down along the curved panel allowing it to rest on top of the Table Brackets and inside the Button Support Bracket groove. For Customer Service Call: Page of 4...
- Page 4 7. Tighten the screws fully in the sequence 1-4 shown at right. CAUTION: Using screws longer than 16mm WILL damage the Work Surface! Legola Trapezoidal Shelf-9512 (shown with 40” Curved Panel) For Customer Service Call: Page of 4 (800) 433-6614...