Troubleshooting - Pyle PLCD20CH Operating Instructions Manual

TROUBLESHOOTING

An error made in operation or in the connections is sometimes mistaken for a failure
or breakdown. Perform the checks described in the following table before calling in
the servicing engineer.
Symptom
No power.
Magazine cannot
be installed.
CD is not played.
Noise is heard
during playback
or sound is
intermittent.
Error Messages showing on display of controller:
E-01
E-07
Cause
Improper connection.
Direction in which it is
inserted is wrong.
Disc has been loaded
upside down.
Large scratches on disc or
warped disc.
Extremely dirty disc.
Transit screws still in place.
Built-in anti-vibration
board is installed in wrong
direction.
Cause
Mechanism problem.
Improper magazine
installation.
Improper magazine
installation.
Disc has been loaded up
side down.
Not original disc.
Laser lens in high humidity.
Dirty disc
www.pyleaudio.com
Check connections.
Insert it in proper direction.
Load disc with play side facing
up.
Compare sound with another
disc. If sound from second disc
is acceptable, first disc is
defective.
Clean disc.
Remove screws (x 3) on bottom
of unit and then use.
Install board in proper direction.
(Refer to "installation" in
Operating Instructions.)
Press "RESET" button.
Eject magazine and try again.
Eject magazine and try again.
Load disc with label facing up.
Try another original disc.
Turn on the car and wait
approximately one hour.
Clean the disc and load the disc
as instruction manual mentioned.
23
Remedy
Remedy