Page 3
Warning ICP DAS assumes no liability for any damage resulting from the use of this product.ICP DAS reserves the right to change this manual at any time without notice. The information furnished by ICP DAS is believed to be accurate and reliable.
Additionally, the RF channels and Group IDs are adjustable, which is helpful to avoid interference encountered when two RFU-900 networks are adjacent. The RF channels and the Group IDs can be configured in order to distinguish and control the different RFU-900 networks.
Step 2: Install .NET Framework 3.5 component The RFU-900 Utility tool requires the “.NET Framework 3.5 components”. If your PC’s environment does not has “.NET Framework 3.5 components”, it will start to install .NET Framework 3.5 components from the web site, after executing the “Setup.exe” file.
Page 11
After installing the .Net Framework components, the software will continue to install the Utility tool. Click the “Next” button to continue. Select the installation path of the RFU-900 Utility and click the “Next” button. RFU-900 (RS-232/RS485 to LoRa Radio Modem) User Manual Version 1.0.0 Page:...
After installing the utility tool, please follow the following steps to set up the communication between the Utility and the RFU-900. Step 1: Connect the PC available COM port with the RS-232 port of the RFU-900 device via CA-0910 cable. Users can find the communication cable (CA-0910) in the product box.
Page 14
Step 3: Execute the RFU-900 Utility tool. Step 4: Select the necessary PC’s COM Port which connected with the RFU-900 module. And then press the ‘Open’ button to connect with module. Step 5: After successfully connected with the module, all device parameters will be shown as below picture.
Page 17
0 ~ 15 dBm. Step 7: Press the save button to save all device parameters into module Step 8: After setting, switch the RFU-900 “Init.” switch to “Off” position and reboot the module. RFU-900 (RS-232/RS485 to LoRa Radio Modem) User Manual Version 1.0.0...