Replace Headphone Jack On The Wired Remote Control; Service; Returning Equipment To Life Fitness - Life Fitness ATV15-***D-02 Owner's Manual

When digital broadcasting services begin operating in an area some masthead amplifiers (boosters) operating at maximum
output or maximum gain may need to be turned down to avoid signal overload for digital receivers. This matter should
be determined by an antenna installer, who will be able to adjust the amplifier for you.
Please note that performing this operation may affect any existing analog signals, so you MAY need to find a medium
point between adequate analog reception and good digital reception.

Replace headphone jack on the wired remote control

Check the headphone jack when you cannot hear audio or the audio quality is poor. The headphone jack is designed
to be easily and quickly replaced in the facility.
1. Take out headphone jack.
2. Disconnect audio cable.
3. Slide the stereo plug on the audio cable in the new headphone jack.
4. Replace the headphone jack.
Important: Do not stretch, crimp or damage the cable. Cables damaged by improper installation will not be
covered by the warranty.

Service

Any service, other than cleaning or user maintenance, must be performed by an authorized service representative.
For information about product service or operation, please contact Life Fitness Customer Service.
Important: Do not attempt to service any of the Attachable TV System products except the service described in
this manual.

Returning Equipment to Life Fitness

To return equipment to Life Fitness for any reason, you must contact Life Fitness to obtain a return maintenance
authorization (RMA) number (see page one for contact information).When you request an RMA number, please explain
why you are returning the equipment.
Important: Equipment must be shipped with an RMA number in order for Life Fitness to process the return.
Page 37 of 39