Table of Contents
Advertisement
Stringing / Tuning Procedure:
Place the ball end of the string on the
bridge string holder. Hold down the ball
end and feed the string to the tuner.
The tuner's post has a slot with a hole in
the center. Put the string in that hole before
you start winding. This system avoids the
string poking out to the side of the tuner
and stabilizes the winding and thus the
tuning.
2 - 4 windings around the post are ideal for
good tuning and stability.
6
Cut the string approximately 8 cm (3.2
behind the tuner. You'll need this excess
length for the windings around the tuner's
post.
Tighten the string while winding it around the
post. This avoids string slippage and
increases tuning stability.
)
"
Advertisement
Table of Contents
