Table of Contents
Advertisement
Connecting the Display (Figure 8.1)
To setup this display, please refer to the following figure and procedures.
1. Be sure all equipments are off.
2. Connect the DC power cord to the power connector; plug one end of the
AC power cord into the power adapter, and then the other end into an
electrical outlet(
3. Connect the VGA signal cable from display VGA input connector to the
15-pin connector of your host computer and tighten the screws(
4. For the PC with DVI digital output: Connect the DVI signal cable to the
connector of the display card in your computer; connect the other side to
the DVI-D input port of your display. Tighten the screws(
5. Turn on your computer and display.
Note:
To ensure the LCD display can work well with your computer, please
configure the display mode of your graphic card to make it less than or equal
to 1280 x 1024 resolution and make sure timing of the display mode is
compatible with the LCD display. We have listed the “Compatibility Modes”
of this LCD display in appendices for your reference.
u
).
English
v
).
w
).
7
Advertisement
Table of Contents
