Yamaha MIE-3XG Manual page 12

Important Information
This product utilizes an external power supply (adapter). DO NOT connect this product to any power supply or
adapter other than one described in this manual, or specifically recommended by Yamaha.
This product should be used only with the components supplied or a table that is recommended by Yamaha.
SPECIFICATIONS SUBJECT TO CHANGE: The information contained in this manual is believed to be correct at
the time of printing. However, Yamaha reserves the right to change or modify any of the specifications without
notice or obligation to update existing units.
This product, either alone or in combination with an amplifier and headphones or speakers, may be capable of
producing sound levels that could cause permanent hearing loss. DO NOT operate for long periods of time at a
high volume level or at a level that is uncomfortable. If you experience any hearing loss or ringing in the ears, you
should consult an audiologist.
IMPORTANT: The louder the sound, the shorter the time period before damage occurs.
NOTICE: Service charges incurred due to a lack of knowledge relating to how a function or effect works (when
the unit is operating as designed) are not covered by the manufacturer's warranty, and are therefore the owner's
responsibility. Please study this manual carefully and consult your dealer before requesting service.
FCC Information (U.S.A.) – MIE-3XG
1. IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT! This product, when installed as indicated in the
instructions contained in this manual, meets FCC requirements. Modifications not expressly approved by
Yamaha may void your authority, granted by the FCC, to use the product.
2. IMPORTANT: When connecting this product to accessories and/or another product use only high quality
shielded cables. Cables supplied with this product MUST be used. Follow all installation instructions. Failure to
follow instructions could void your FCC authorization to use this product in the USA.
3. NOTE: This product has been tested and found to comply with the requirements listed in FCC Regulations,
Part 15 for Class "B" digital devices. Compliance with these requirements provides a reasonable level of assur-
ance that your use of this product in a residential environment will not result in harmful interference with other
electronic devices. This equipment generates/uses radio frequencies and, if not installed and used according to
the instructions found in the users manual, may cause interference harmful to the operation of other electronic
devices. Compliance with FCC regulations does not guarantee that interference will not occur in all installa-
tions. If this product is found to be the source of interference, which can be determined by turning the unit
"OFF" and "ON", please try to eliminate the problem by using one of the following measures:
• Relocate either this product or the device that is being affected by the interference.
• Utilize power outlets that are on different branch (circuit breaker or fuse) circuits or install AC line filters.
• In the case of radio or TV interference, relocate/reorient the antenna. If the antenna lead-in is 300-ohm
ribbon lead, change the lead-in to co-axial type cable.
• If these corrective measures do not produce satisfactory results, please contact Yamaha Corporation of
America, Electronic Service Division, 6600 Orangethorpe Ave, Buena Park, CA 90620.
The above statements apply ONLY to those products distributed by Yamaha Corporation of America or its subsid-
iaries.
4. MIE-3XG K G
Eyboard uIdE
| [ ]
paGE