Advertisement
This section describes the various boot modes that are supported on the ARTIK 530 Development Board. Table 2 and Figure 6
show how to manipulate SW402 and where SW402 is located on the Interposer Board to set the various booting options that
are available on the ARTIK 530 Development Board.
st
When 'eMMc 1
Boot' is selected as a booting option, the system will first try to boot from eMMc, if this fails the system will
search for an SD Card to boot from. If booting from the SD-Card also fails the system tries to boot from USB. When choosing
the SD-Card booting option, the system starts with booting from SD, and if this fails will continue to try a USB boot. When USB
is selected as the booting mechanism of choice, only a USB boot will be attempted.
st
SW402
eMMc 1
Boot
SD Card 1
1
Off
2
Off
3
X
4
Off
st
st
Boot
USB 1
Boot
Off
On
Off
On
X
X
On
X
13
Advertisement
