Table of Contents
Advertisement
DATA LOGGING
The tracker device uses an internal memory for
data logging that can store up to 20,000 records.
When the device loses the GSM/GPRS signal,
GPS reception continues and all positions are
logged into the memory depending on the present
mode of the tracker. Once reconnected to a
GSM/GPRS network with a satisfactory signal,
stored GPS positions are automatically sent.
If the device is used without a sufficient
GSM/GPRS signal for a long time, it may
automatically overwrite the memory, starting from
the oldest recorded item to the newest.
If the device is not in the direct view of the sky,
acquiring a GPS position may take longer or might
not be acquired at all (e.g. inside a building, deep
in luggage, in cargo spaces, etc.).
In order to preserve the battery life and attain the
correct information through the applications as fast
as possible, we recommend waking up the TICK
device in places where conditions of the GPS
signal reception are favourable.
Please note:
When using your TICK device for very first time, we
strongly recommend following these simple steps:
•
Recharge it fully (see page 10)
•
Send the command for Activated by motion
mode to it (see page 8)
•
Carry it outside for at least 5 minutes to
record the GPS position
•
Check the overall status of the TICK device
from the TICK tracker application
A correct GPS location fix may take up to 10
minutes. The TICK will only start to behave
according to the set operating mode once an
accurate GPS position has been fixed.
SIM card
The device is already equipped with a SIM card.
Data transmission services are not included in the
price of the device. The price for services is
charged separately according to the NAM system
services contract and according to chosen invoice
period.
OPERATING MODES
The device allows you to choose between 6 modes
of operation. The maximum time that the device
can operate in the field without the need to
recharge it is influenced by the specific modes
used.
Any TICK device operating mode can be switched
by commands which are only available within the
TICK tracker application.
Activated by motion
Vibrations trigger GPS
position locating. Posi-
tions are logged at
fixed 10 sec intervals
and sent to the application every minute. The
TICK's manipulation info is sent immediately.
8
Advertisement
Table of Contents
