David Walters Shani II Operation Manual page 10

Power boat
Table of Contents

Advertisement

Check The furnace EXHAUST PORT which is located starboard side aft, for any obstruction such as
fenders or lines. Do not block this opening when operating the furnace. Heat will damage fiberglass or
rubber. Once it is on, allow it to run for at least 15 minutes before turning it off. Turn 'off' the furnace
heater by turning switch back off.
Built-in Cabin Heat (AC)
ELECTRIC HEATERS are available when connected to shore power, or when underway when using them
on LOW setting.
Engine Heat (DC)
This CABIN HEATER is available while underway. The engines provide heat in the same way as a car
heater. Press the HEATER FAN ROCKER SWITCH located in DC PANEL. Use the corresponding
thermostats.
ELECTRONICS
VHF Radio
There are 2 VHF RADIOS. The first is located at lower helm, the second on the flybridge. Make sure the
two breakers are on located at the DC PANEL. Always monitor channel 16 while underway.
Depth Sounder
There are 2 DEPTH SOUNDERS, one at lower and the upper helm. To activate the upper DEPTH
SOUNDER, press the switch bridge instrument panel.. Set the scale, shallow alarm, and deep alarm as
desired. The sounder should provide reliable readings in shallow waters. If in doubt, switch it off, then turn
it back on to reset sounder. If your reading is blinking, it is a FALSE reading. False readings can occur in
depths of more then 200 feet or in areas of string currents or tides.
Radar
To operate the Raytheon RADAR press and hold the POWER button to turn the radar on. To turn off,
press and hold POWER button about 3 seconds. Remember you are not allowed to travel in FOG or in
serious wind conditions..
Global Positioning System (GPS)
A fixed mount GPS unit is tied into the laptop and is on the nav station. Ascertain that your breaker is on
and then press the red color 'on/off/light' button to activate.
It works by turning on PC and launching
COASTAL NAVIGATOR.
Note
--
GPS is considered a navigation aid. Do not rely on it. Compasses, charts, and dividers are the
tools to plot position, course, and speed.

Advertisement

Table of Contents
loading

Table of Contents