Advertisement
Quick Links
Model CT-5A Tesla meter
Technical specifications:
(1) Measuring range (mT):0~10~50~100~250~1000~2500mT
(2) Polarity of Magnetic field: N and S
(3) Accuracy: 50
100
250
1000
Operating temperature:+5℃ ~ +40℃
Overall dimension of Hall sensor:3.2x1.1x35mm
Using position: Horizontal position
Power supply: 220V+/-10%
Overall dimension of tesla meter: 210x160x100mm
Operating instructions:
1.Caution:
(1) Hall sensor in the probe is fragile. Care should be taken to protect the Hall element from excessive stress
due to shock, pressure, bending and bump.
(2) Tesla meter should be kept and used by assigned person, so as to minimize the possibility of damage.
(3) User manual should be read carefully before operation.
(4) Before operation, please check if there's calibration constant marked on the probe.
(5) Before operation, please check if the copper sleeve on the hall sensor is tight enough, if not, please fasten
it.
(6) Hall sensor should not be used in environment with strong sunlight, temperature higher than 60℃ and
corrosive gas.
(7) Tesla meter should not be stored near strong magnetic field, and should be keep at least 1M afar from the
+/-2.5%
0~10
+/-5%
Advertisement
Summary of Contents for Yuxiang CT-5A
- Page 1 Model CT-5A Tesla meter Technical specifications: (1) Measuring range (mT):0~10~50~100~250~1000~2500mT (2) Polarity of Magnetic field: N and S (3) Accuracy: 50 +/-2.5% 0~10 +/-5% 1000 Operating temperature:+5℃ ~ +40℃ Overall dimension of Hall sensor:3.2x1.1x35mm Using position: Horizontal position Power supply: 220V+/-10%...
- Page 2 same. 2. Operating instructions (1) Zeroing—Turn the measuring knob to “OFF”(关) first, adjust the mechanical zero setter(0) in the instrument's center, to make the pointer locate on zero line(0). Caution: --This process should be adjusted carefully before connecting power supply, so as to ensure the accuracy rate.
- Page 3 a. when in use(especially measuring 10~100mT), if the probe is pressed, distorted or temperature on the magnets to be measured changes, the zeroing process should be performed to eliminate errors. b. Due to the high sensitivity of 10mT measuring range, tester should check frequently if the zero line”0” changes? If so, zeroing process should be performed before measuring.
- Page 4 5. User manual: 1 copy 6. product’s qualification certificate: 1 copy 7. fuse: 2pcs...