Acrox Technologies MS3 Owner's Manual

3-in-1 professional presenter mouse

Advertisement

Quick Links

3-in-1 Professional Presenter Mouse
OWNER'S GUIDE
Ver.1.0
Please DO NOT direct the laser beam at anyone's eye.
CAUTION: To use this product properly, please read the user's guide before installation
Federal Communications Commission (FCC) Notice
This device complies with Part 15 of the FCC rules. Operation is subject
to the following two conditions
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits of a
Class B digital device, pursuant to Part 15 of the FCC Rules These limits
are designed to provide reasonable protection against harmful
interference in a residential installation This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications, However, there is no guarantee that interference will not
occur in particular installations If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures :
1. Reorient / Relocate the receiving antenna.
2. Increase the distance between the mouse and receiver.
3. Connect the equipment into an outlet on a circuit different from that the
receiver is connected.
4. Consult the dealer or an experienced radio /TV technician for help
CAUTION:
Change or modifications not expressly approved by the manufacturer responsible for compliance could void the user's
authority to operate the equipment

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MS3 and is the answer not in the manual?

Questions and answers

Summary of Contents for Acrox Technologies MS3

  • Page 1 3-in-1 Professional Presenter Mouse OWNER'S GUIDE Ver.1.0 Please DO NOT direct the laser beam at anyone’s eye. CAUTION: To use this product properly, please read the user's guide before installation Federal Communications Commission (FCC) Notice This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including...
  • Page 2 Welcome Thank you for choosing 3-in-1 Professional Presenter Mouse. This devices can offer 3-in-1 solution including a RF laser presenter, a handy trackball and a cordless laser mouse. It gives you remove control of your onscreen presentation with up to arrange of 10 meters.
  • Page 3: Hardware Installation

    Receiver Channel Reset Button Battery Charging Point Hardware Installation Installing the Batteries Open the batter cover and insert the 2 *AA batteries following the polarity instructions as shown in the battery chamber.
  • Page 4 Installing the Charger and the Receiver The receiver (charger) is connected to your computer via a cable. It needs to plug into your computer by a USB port or a mouse port. Connec t to the USB or Mouse p ort of your c om p uter For USB port installation USB Port Windows 98 (or higher) is required for USB port...
  • Page 5 Using the Presenter Mouse Laser Pointer Press/Not Press the Laser Bean Control Button to control Laser Bean On/Off. The operation range is up to 10 meters. How to use the 8D Scroll Ball You can control the Windows Scroll Bar horizontally and vertically through scroll the roll the Scroll Ball toward the direction you want directly.
  • Page 6 Recharging...
  • Page 7: Troubleshooting

    Troubleshooting A. Presenter Mouse does not work upon installation. Try one or more of the following: For optimal performance, place adjust the angle of the receiver to find the best performance. Make sure you have installed the batteries correctly. Press the “Channel Reset” button on the receiver, and then press the “Channel Reset”...

Table of Contents