Advertisement
INSTALLATION INSTRUCTIONS
Flood Light Slim Line 10
GANL-FLSL-10W-24V
Flood Light Slim Line 20
GANL-FLSL-20W-24V
Flood Light Slim Line 30
GANL-FLSL-30W-24V
NOTE:
1.
Gardens at Night fittings should only be connected to approved Gardens at Night 24VDC Constant
Voltage (CV) Power Supplies. FAILURE TO DO SO WILL VOID WARRANTY.
2.
Gardens at Night fittings must be wired in parallel and connected in accordance with installation
instructions provided (including soldering of cable joins and sealing using Adhesive Lined End Caps).
FAILURE TO DO SO WILL VOID WARRANTY.
3.
Fittings are polarity sensitive and need to be connected positive (+) fitting lead to positive (+) incoming
and exiting feed cables and negative (-) fitting lead to negative (-) incoming and exiting feed cables.
4.
Do not carry fittings by lead as it may cause damage.
5.
Do not connect fittings to constant current (CC) power supplies or AC transformers as this will cause
permanent fitting failure and VOID WARRANTY.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Gardens at Night Flood Light Slim Line 10
-
Page 1: Installation Instructions
GANL-FLSL-30W-24V NOTE: Gardens at Night fittings should only be connected to approved Gardens at Night 24VDC Constant Voltage (CV) Power Supplies. FAILURE TO DO SO WILL VOID WARRANTY. Gardens at Night fittings must be wired in parallel and connected in accordance with installation instructions provided (including soldering of cable joins and sealing using Adhesive Lined End Caps). - Page 3 FITTING INSTALLATION INSTRUCTIONS „ Remove two attachment bolts including washers using appropriate spanner (A). „ Carefully store bolts and washers for later use. „ Remove mounting bracket from light fitting (B). „ Position mounting bracket in desired location. „ Ensure mounting bracket is correctly oriented to light desired area.
- Page 4 Torch* and apply solder (A). „ Solder should fully penetrate all strands (B). „ Trim solder with side cutters and carefully remove any sharp edges (C). „ Repeat for other cable join. Solder Butane Gas Torch and solder available from Gardens at Night.
- Page 5 Adhesive should be visible from ends of oversheath (C). Adhesive Lined End Caps are available in various sizes to suit different low voltage cable sizes. Caps should be at least 1/3 larger than join and are available from Gardens at Night.
- Page 8 The customer must bear the cost of the transport supply of goods and services which cannot be excluded, restricted or modified. of the Product to and from Gardens at Night or its authorised repair agent, and all insurance of the Product.
Need help?
Do you have a question about the Flood Light Slim Line 10 and is the answer not in the manual?
Questions and answers