Art Andersen CPH AACPH-RC1-EU Manual

Copenhagen Blind Wall Controller Copenhagen Blind Wall Controller
Productno: AACPH-RC1-EU
The Wall Controller is a multi-function button which is able to
control the position of a blind and switch appliances on/off. The control the position of a blind and switch appliances on/off. The
Wall Controller consists of a wall bracket and a portable
The portable controller has an integrated magnet which gives the The portable controller has an integrated magnet which
user the possibility to place it in the wall bracket or on any metallic
surface. This product can be included and operated in any Z- surface. This product can be included and operated in any Z
TM
Wave network with other Z-Wave
manufacturers and/or other applications.
The rotation function to control position of blind works when to control position of blind works when the
controller is fitted upright or stick on the wall is fitted upright or stick on the wall, in all other
situations the controller will work only as a binary switch.
Please provide a 5 DVC voltage through Micro USB Port to Please provide a 5 DVC voltage through Micro USB Port to
wake the device up before the first using.
Function button which is able to
portable controller.
in the wall bracket or on any metallic
TM
certified devices from other certified devices from other
as a binary switch.

Z-Wave Network operation

Wave Network operation
Auto inclusion: (add using Network Wide Inclusion)
primary controller in inclusion mode then press the Button primary controller in inclusion mode then p
once.The LED pointer will flash red up to 30 seconds while it waits The LED pointer will flash red up to 30 seconds while it waits
to be included. When successfully included it will turn on a green to be included. When successfully included it will turn on a green
surround light for 1 second.
Manual inclusion:(add using Network Wide Inclusion)
primary controller in inclusion mode. With the wall controller primary controller in inclusion mode
vertical, point the LED pointer to area A (shown in Fig. 1) and
press the Button three times within 1.5 seconds. three times within 1.5 seconds. The LED pointer
will flash red up to 30 seconds while it waits to be included. When will flash red up to 30 seconds while it waits to be included. When
successfully included it will tu
second.
Exclusion:(remove) Set the primary controller in exclusion mode. Set the primary controller in exclusion mode.
With the wall controller vertical, point the LED pointer to area A, With the wall controller vertical, p
then press the Button three times within 1.5 seconds. utton three times within 1.5 seconds. The LED
pointer will flash red once. When successfully excluded it will enter pointer will flash red once. When successfully excluded it
a 30 seconds auto inclusion mode and the LED pointer will flash a 30 seconds auto inclusion mode
red.
Reset to default:With the wall controller vertical, point the With the wall controller vertical, point the LED
pointer to area A then press the Button four times within 2 pointer to area A then press the
seconds and hold at fourth. The red LED pointer will light for 5 seconds and hold at fourth. The red LED
seconds, release the button within 2 seconds while the LED goes seconds, release the button within 2 seconds while the LED goes
out. The LED will flash for 1 second if reset succeeded, or LED will out. The LED will flash for 1 second if reset succeed
flash once if not succeeded.
Note: Use this procedure only in the event that the primary Use this procedure only in the event that the primary
1
using Network Wide Inclusion)Set the
using Network Wide Inclusion) Set the
pointer to area A (shown in Fig. 1) and
rn on a green surround light for 1