Remote Control Functions - Redback A 2702A Operating Instructions Manual

REDBACK ® A 2702A AM/FM RDS Tuner
1
5
7
8
12
OPERATION:
TUNING A FREQUENCY: MANUAL TUNING
Use the UP or DOWN buttons on the front panel or the remote control to manually tune to a desired frequency. Every time
the UP or DOWN button is pressed once, the radio frequency is changed by 0.05MHz steps for FM and 9kHz steps for AM.
When either the UP or DOWN button is pressed and held for two seconds, the automatic tuning starts. The scan will stop as
soon as it locks onto a viable station frequency.
TUNING A FREQUENCY: DIRECT TUNING
The quickest way to tune to a known station is to enter the frequency numbers directly. This can be achieved using the DI-
RECT button on the front panel or the remote control. Press the DIRECT button once. If you fail to enter any numbers within
three seconds, the function will deactivate and the tuner will retain its current channel status. Use the number buttons to
enter a station frequency to fill the blank spaces on the LCD.
There are five blanks spaces for FM and four blank spaces for AM tuning. FM frequencies below 100.10MHz have only four
places and AM frequencies below 1008 kHz have only three places, and the direct tuning function is programmed to account
for this. Press DIRECT again to confirm the frequency entered. The tuner will jump directly to this exact position on the dial
in either the AM or FM bands. (E.G. Press DIRECT, enter 9+3+7+0 for frequency 93.70 MHz station, and press DIRECT
again.)
If the user enters fewer numbers than required, then when you press DIRECT, it will not accept it. If the input frequency is
beyond the tuner's range, the LCD will display the error message 'ERROR'.
Page 3

REMOTE CONTROL FUNCTIONS:

1. 1~10/0 – Numeric keys for frequency tuning and memory storage
locations.
2. DOWN – Tune frequency in decreasing numerical value.
3. UP – Tune frequency in increasing numerical value.
14
4. BAND – Switch between AM and FM bands.
4
5. DIRECT – Tune to a specific station using the numeric keys to enter
the frequency.
9
6. SLEEP – Sets the duration for the playback timer that counts down
10
the minutes to power standby.
13
7. ME DOWN – Scroll down through the Memory presets.
8. ME UP – Scroll up through the Memory presets.
11
9. MEMORY – This button can store a station frequency into a
3
Memory preset number.
2
10. ASM – Auto Search Memory. Automatically scans the entire band
(AM or FM) and stores the strongest frequencies found in memory.
6
11. MO/ST – Mono / Stereo - change between mono and stereo mode
for FM radio tuning.
12. MUTE – Press to turn audio off and on. Volume level is retained.
'MUTE' flashes on LCD.
13. +10/- – Use this button to activate FM stations in memory
locations higher than 10.
14. RDS – Changes the RDS (Radio Data System) code information
shown on the LCD for FM stations that transmit RDS.