Advertisement
Table of Contents
are from the manufacturer and may not last very long
depending on how long they have sat on the shelf.
We just ship them as they come to us, we don't guar-
antee them. Many people have used the recharge-
able batteries, works fine.
Battery compartment 2AA
To Reach Stibbar for supplies on your Tattooer:
Emails: stibbar@att.net
http://www.stibbar.com
16
are from the manufacturer and may not last very long
depending on how long they have sat on the shelf.
We just ship them as they come to us, we don't guar-
antee them. Many people have used the recharge-
able batteries, works fine.
Battery compartment 2AA
To Reach Stibbar for supplies on your Tattooer:
Emails: stibbar@att.net
http://www.stibbar.com
16
Switch
Head
Switch
Head
stibbar@att.net
Your Tattooer comes ready to go, so gather all your tat-
too items together.
Everything that came in your kit along with,
!"
Water dampened paper towel,
!"
preparation H cream, and
!"
alcohol for cleaning ear before tattooing.
stibbar@att.net
Your Tattooer comes ready to go, so gather all your tat-
too items together.
Everything that came in your kit along with,
!"
Water dampened paper towel,
!"
preparation H cream, and
!"
alcohol for cleaning ear before tattooing.
Advertisement
Table of Contents
Summary of Contents for EZ Tatt B000V1WGLO
- Page 1 are from the manufacturer and may not last very long depending on how long they have sat on the shelf. We just ship them as they come to us, we don’t guar- antee them. Many people have used the recharge- able batteries, works fine.
- Page 2 This Tattooer comes with a cap that pro- move the barrel up or down. At the top on the up- stroke the needle should show 1/16 of an inch. That’s tects it during shipping or when you go not a lot, about the thickness of a dime, you don’t want to a show.
- Page 3 Turn the motor on and then dip the tube into the After the needle is in place, take the ink cup, holding it there for at least five (5) sec- head, get a good strong light behind onds. Count 1001, 1002 etc. you and THREAD the needle Holding it in the ink that long will allow the tube carefully through the barrel.
- Page 4 Very out of tinue running. Make sure See in the photos, the needle goes into the rubber tube proportion and the end of the needle pokes through that rubber that you are Comfortable here but tube. when tattooing—comfort is shows where the ink To remove the needle, grasp the rubber tube either Inner...
- Page 5 The Needles bit so that the needle can push HAVE to be han- the ink into the skin smoothly. dled with care. They each have individual points that can be bent if you’re not careful. Practice on a banana.. Get the If you’re just doing a cleaning on feel of the tattooer, get used to writing block let- your Tatt, do NOT remove the...
- Page 6 There are two arrows that are lined up, to remove the Rabbits and other small animals: Ears: The ears on animals head, just twist counter-clockwise 1/4 have two large veins and multi- turn so that the arrows are no longer ple small ones around the pointing at each other and pull straight edges.
- Page 7 you take care to clean it very well before tattooing. cohol, get all oils and flakes off. Especially on lop Also be sure to use antibiotic cream afterwards. ears, get old dry skin off. The tattoo will take better as the oils can interfere.
- Page 8 you’ll be able to flip the ear over, do the tattoo quickly You’ve hopefully handled them enough so that they and be done before the rabbit knows you’ve done any- are used to being picked up and played with and they thing.
Need help?
Do you have a question about the B000V1WGLO and is the answer not in the manual?
Questions and answers