Shiningintl Alexa Operation Manual

Portable wireless smart voice control bluetooth wifi internet music radio speaker with amazon alexa

www.shiningintl.com

Shiningintl Alexa speaker operation manual

(general instruction)

1. Overview

Shiningintl has two type of Alexa enabled smart speakers , one is the "far field Alexa enabled smart

speaker", a far field alexa smart speaker can be waked by saying "alexa" without any hand motion need ,

there is an Mic-array inside the speaker, the Mic-array can always get the voice signal and analyse the

voice to match the wake up word "alexa" , if the speaker detect the "alexa" word in air, it will go into

the command waiting mode to wait for voice command.it is really easy to control your smart speaker

with voice; the another one alexa enabled speaker is a "near field Alexa enabled smart speaker", the

near field alexa enabled smart speaker doen't support voice wake up, when the users want to interact

with the speaker, the users need to press the "Alexa on" button at first, and then speak to the speaker.

Buttons:

Normally, the speaker has 4 buttons: power/mode button, volume up, volume down, Alexa on

Power/mode button: press and hold to power the speaker on or off, press to switch between wifi and Bluetooth

after power on.

Volume up: press to adjust volume up

Volume down: press to adjust volume down

Alexa on button: press to activate amazon Alexa and waiting user to speak command. For a far field alexa speaker,

the user just need to say "alexa" command, and it is not necessary to press the button. But most of our products

have this button on body.

Before go ahead the Shiningintl alexa enabled smart speaker, the users need to install an application on its smart

Table of Contents

Do you have a question about the Alexa and is the answer not in the manual?

Page 1 Mic-array inside the speaker, the Mic-array can always get the voice signal and analyse the voice to match the wake up word “alexa” , if the speaker detect the “alexa” word in air, it will go into the command waiting mode to wait for voice command.it is really easy to control your smart speaker...
Page 2 >> When the speaker and your phone are successfully connected, a voice prompt will announce the connection. >> With the Wi-Fi connection complete, the app will automatically begin the process to connect to Amazon Alexa. Follow the On-screen prompts to link Alexa with the speaker and begin using Amazon Alexa Voice Services. You will need to enter your Amazon account information to use Alexa.
Page 3 Following the prompt and enter your Wi-Fi network password when ready Press “Alexa on” button until you Press “Next” to switch into Amazon hear the voice prompt ”connecting to Alexa Setup your device, it may take 1 to 3...
Page 4 Enter your Amazon account name and password. You must have an Amazon account to access Alexa services. Press “Next” to complete setup and begin using your speaker with Amazon Alexa...
Page 5 4. Bluetooth Wireless 5. The Shiningintl alexa enabled speaker can also connect to devices via Bluetooth. Follow the steps below to pair to a Bluetooth enabled device. >> Power on the speaker and press the Power button to select Bluetooth Mode.