INFLATING & DEFLATING PUFFER
PUFFER INFLATION
STEP 1: PUMP SET UP
Attach pressure gauge to pump. Begin
with pressure gauge dial facing the
ground and twist clockwise 180 degrees
until dial is securely fastened and facing
upward.
Fasten air hose to pressure gauge.
STEP 2: INFLATING PUFFER
Locate the air valve on tail section of the
PUMP ASSEMBLY
board deck.
Open valve cover.
Make sure the inner valve is disengaged
in the "up" position (See opposite
illustration).
Connect air hose to air valve.
Inflate PUFFER to 10-12 psi.
Disconnect air hose from valve. Inner
valve will prevent air from escaping
when disengaged in the "up" position.
Close valve cover.
LOCATING AIR VALVE
FOR WARR ANT Y IN FO RMAT IO N , PAR TS/ACCES SO RIES , C AL L 1-800- 370-0745
OR CONTAC T US TH R O UGH O UR WEB S ITE, W W W.J IM M YS T YKS . COM
8
INNER VALVE POSITIONING
IMPORTANT
The inner valve will prevent air from
escaping when disengaged ("Up"
position).
The inner valve will allow air to
escape freely when engaged
("Down" position).
PUFFER DEFLATION
Open valve cover.
Depress inner valve and turn clockwise
to lock in the open or "down" position.
Allow air to freely escape PUFFER for a
few minutes.
Beginning at the nose, tightly roll up
PUFFER to force remaining air through
the air valve.
S EC T IO N 3
INNER VALVE DISENGAGED (UP POSITION)
AIR PREVENTED FROM LEAVING SUP
INNER VALVE ENGAGED (DOWN POSITION)
AIR ESCAPES FREELY FROM SUP
Q U E S T I O N S / C O M M E N T S :
1 - 8 0 0 - 3 7 0 - 0 7 4 5
j i m m y s t y k s . c o m
9