Pioneer Metro Installation & Owner's Operation Manual page 3

Assembling your Metro wood fire
Metro Insert firebox
• Remove from within the firebox the plastic bag containing
the bolt kit, two firebricks wrapped in a cardboard wrapper
and then the top baffle assembly
• A 'spacer' washer has been pre-fitted and taped to the top
door hinge pin on the left hand side of the firebox (Refer
Inset A) remove this tape
• Remove the 'cabinet top' which is packed inverted on top
of the firebox and fit it into position over the cabinet sides
as detailed in Diagram 1. Ensure the rear edge is fitted
correctly as shown Diagram 1, Inset 'B', the rear edge of
the cabinet top must fit into the slot provided. Lift the front
to the highest available position and using two of the self
tapping screws from the plastic bag, secure the cabinet top
in place taking care to not damage the insulation blanket.
Note: This panel can be fitted at two height's. If the height of
the fireplace opening will allow, fit the cabinet top in the higher
position, fit screws from inside the cabinet facing out.
• Ensure the insulating blanket is in position on the top of the
cabinet and remains in a sound condition
• Remove the four speed clip nuts from the plastic bag
and fit them to the holes provided in the front edge of the
cabinet as shown in Diagrams 1 and 1A
• Next you need to fit the top baffle.
All insert models feature a two piece top baffle which locates
onto six lugs provided on the side walls of the firebox's upper
chamber, as detailed in Diagram 2 on page 4. The rear baffle
section is 6mm folded steel and has a central locating pin fitted
to its front top surface. Fit this rear baffle through the door
opening and into position in the upper chamber of the firebox.
It is supported on the rear four support lugs and must be hard
back against the rear wall of the firebox with the central locating
pin facing up and towards the front.
Next, locate the front baffle which is a combination baffle
comprising of a 6mm steel plate with a promet (white board)
front extension. Fit this baffle through the door opening and
into position, ensuring the hole provided on its rear edge is
positioned over the locating pin fitted to the rear baffle.
Unwrap the two firebricks from the cardboard wrapper and fit
the side bricks to each side of the firebox. Location lugs are
fitted to the base and rear of the firebox to retain the side bricks
in position, refer to the relevant Diagram 2 on page 4.
Diagram 1 - ECO & LTD Insert Firebox
Spacer Washer
Hinge Pin
Air Control Knob
Handle Spindle
Fascia
Diagram 1A - Smart Insert & LTD Smart Insert Firebox
Spacer Washer
Hinge Pin
Air Control Knob
Spindle
Handle
Fascia
(A)
Cabinet Top
Speed Clip
Fixing Points For
Seismic Restraint
(A)
Fixing Points For Speed Clip
(x4)
Seismic Restraint
(B)
Insert
Cabinet
(x4)
Cabinet Top
(B)
Insert
Cabinet
3