Table of Contents
Advertisement
Care and maintenance instructions
Drain pump
The pump can be accessed from inside the
glassware washer.
4. Cut the power to the glassware washer by
unplugging the unit from the power outlet.
5. Remove the coarse filter and pipe section.
6. Remove the small yellow drain pump access
cover at the left of the bottom drain (see
illustration below).
7. By inserting your finger into the hole, you can
turn the pump blades to release anything
blocking the pump.
8. Reinstall the success cover and filters.
9. Plug the machine in again.
If the glassware washer still does not start and a
whirring sound is heard, the overflow protection
has been triggered.
Shut off the water.
Unplug the unit from the power outlet.
Call Universal Scientific, Inc.
Copyright © 2012 Universal Scientific Incorporated. All rights Reserved.
6210 Campbell Drive. Madison, Ohio 44057-2003 | Phone: 440-428-7800 | Fax: 440-428-8650
(continued)
Do not forget to reinstall the drain pump access
cover.
Lower spray arm
Holes and bearings can sometimes become
blocked.
1. Pull the lower spray arm straight up to release
it.
2. Remove any debris using a needle, toothpick,
or some other similar pointed device. The
spray arms also have holes underneath.
Upper spray arm
The upper basket must be removed before the
upper spray arm can be released.
1. Pull out the upper basket and turn the basket
catch on each runner outward (see
illustration). The basket can now be removed.
2. Loosen the upper spray arm in the same
manner as the lower spray arm and clean it.
www.universalscientificinc.com
Page 19
Advertisement
Table of Contents
