1. Manuals
  2. Brands
  3. McKesson Manuals
  4. Touch terminals
  5. PharmaClik POS ONE
  6. Installation manual

McKesson PharmaClik POS ONE Installation Manual

Hide thumbs
1
2
3
4
Table of Contents

Advertisement

Quick Links

Download this manual
Congratulations on your purchase of PharmaClik POS ONE!
Your system is pre-configured and PharmaClik POS is pre-installed so that installation is as simple as
possible.
This install should take approximately one hour to complete and may need two people to unpack.
Note: We highly recommend the system be set up four to seven (4-7) days before going live to allow the
self-training to take place on the system itself.

Before You Begin

Be sure you have read the PharmaClik POS ONE Planning Guide and prepared your
environment before unpacking the boxes (power, network, counters).

Network Connection

McKesson provides a virtual private network (VPN) service which connects you to our secure network. If
you are using this, follow the Network Setup Instructions below.
If you did not order this service then plug the switch into your existing internet network.
**All instructions are related to the PTS provided equipment.
Last Updated: 8 November 2016
PharmaClik POS ONE
Self-Installation Guide
Page 1 of 4

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PharmaClik POS ONE and is the answer not in the manual?

Questions and answers

Summary of Contents for McKesson PharmaClik POS ONE

  • Page 1 (power, network, counters). Network Connection McKesson provides a virtual private network (VPN) service which connects you to our secure network. If you are using this, follow the Network Setup Instructions below. If you did not order this service then plug the switch into your existing internet network.
  • Page 2 Rear View of the Till Computer (Reference for Till Setup) Com 3 Com 1 PharmaClik POS ONE Till Installation and Setup Instructions Section 1 Unpack Cash Drawer (Box 1) and place in prepared location. Section 2 Unpack the Till Computer (Box 2) a) Place the Till computer into its location (preferably under the counter and out of the way).
  • Page 3 Section 4 Unpack the Monitor (Box 4) a) Connect the monitor arm to the stand. b) Connect the montior to the arm and press until a ‘click’ is heard. c) Slide the cover in place on the back of the monitor. d) Connect one end of the VGA cable to the monitor.
  • Page 4 Section 8 Connect all Equipment to the UPS Battery Backup a) Connect the power cables for the following to the BATTERY BACKUP section of the UPS and NOT the Surge Only section (marked on the back of the UPS box): •...

Table of Contents