Related Manuals for Snoos V2 Keypad
Summary of Contents for Snoos V2 Keypad
- Page 1 Snoos V2 Keypad with NFC tags ©Snoos Copyright 2017 Rev1.0 For updated information see www.snoos.com/support...
- Page 2 Mounting and use: The keypad is best mounted nearby the entrance door. It is used to arm/disarm the Snoos Home alarm system by a NFC tag or a pin code. Up to 5 NFC tags can connect to the keypad.
- Page 3 • Press “#” E.g.: *11117# • The keypad deletes all tags and confirms with a long beep. Successful operation: Keypad confirms with one beep. Failed operation: Keypad confirms with three beeps. ©Snoos Copyright 2017 Rev1.0 For updated information see www.snoos.com/support...
- Page 4 Immediately hereafter - Enter *111194 + New PIN code + # • Enter new 4 digit PIN code Successful operation: Keypad confirms with one beep. Failed operation: Keypad confirms with three beeps. ©Snoos Copyright 2017 Rev1.0 For updated information see www.snoos.com/support...
- Page 5 Lift off the cover • Replace the batteries • Notice the small socket on the PCB • Carefully place fit the pins in of the upper part in the socket • Mount 6 screws. ©Snoos Copyright 2017 Rev1.0 For updated information see www.snoos.com/support...
- Page 6 Swipe the NFC tag one time over the reading field on the keypad. Disarm alarm: • Press ”*” • Swipe the NFC tag twice over the reading field on the keypad. ©Snoos Copyright 2017 Rev1.0 For updated information see www.snoos.com/support...
- Page 7 ©Snoos Copyright 2017 Rev1.0 For updated information see www.snoos.com/support...
Need help?
Do you have a question about the V2 Keypad and is the answer not in the manual?
Questions and answers