2-3 oz. in bowl Parts List………………………………..……………………..3 Speci cations………………………………..………………..3 Unpacking and Preparing Your Diffuser for Use….....5 Ready to Diffuse ..............6 How to Use the Control Panel Buttons ..………..…...…7 Cleaning Your Diffuser……………………….…..…….…8 Careful Operation and Safety Instructions ..…………...9 Troubleshooting……………………………..……………10 ® H2EO AirCare Ultrasonic Diffuser Warranty…..……11...
Page 4
Director Nozzle Custom, Lightweight Diffuser Lid with Directional Vane Energy-Ef cient Power Adapter (US and EU adapters - style may vary) Water Level Sensor Transducer Air Duct Cover Maximum Water Level Important Caution: Fill Line Under this cover are two air vents. Do not allow essential oil and water to spill into these vents.
UNPACKING AND SETTING UP YOUR DIFFUSER Remove the diffuser from its box. Lift the lid off the diffuser. Take the director nozzle pack from inside the diffuser bowl. Remove one director nozzle from the pack and place it at side down in the recessed hole at the top of your diffuser’s lid.
READY TO DIFFUSE Carefully pour up to one cupful (8 oz/240mL) of clean, ltered water into your diffuser’s bowl. Again, do not over ll! Your maximum water ll line is the top of the VERTICAL LINE on the inside back of the diffuser’s bowl. Onto the surface of the water drip 5-10 drops of any pure essential oil, or a blend or combination of pure essential oils.
HOW TO USE THE CONTROL PANEL BUTTONS POWER (center button) On the Blue Lights Model: 1. Press POWER button to turn on solid blue display lights. 2. Press POWER button again to turn all lights off (while still diffusing). POWER (center button) On the Multi-Colored Lights Model: 1.
3. By pressing the MODE button twice, your diffuser is in Mode 3 (third green bar will remain lit). In Mode 3 your diffuser will diffuse intermittently: on for 3 seconds, then rest for 40 seconds, until low water level is reached, and it will automatically shut itself off. 4.
If in doubt, contact us at info@plantextractsinc.com. We will be happy to offer you assistance. ® 2. Only use the H2EO power adapter supplied with this diffuser. 3. Never plug in the adapter before lling the diffuser to the correct level with water.
allow it to cool down. Re ll and restart. If diffuser will not restart, it has been damaged by the over lling and must be repaired. Note: Warranty does not cover misuse. Lights ash, diffuser will not start: • Unit has developed a malfunction or has detected a fault. Unplug, re ll if necessary, reconnect and turn the diffuser on again.
Page 12
EO/water spillage inside the machine to dry out. Try it again and if it still does not diffuse, send the diffuser AND adapter, lid and nozzle to Plant Extracts International Inc. (PEI). For best service, print and complete the Service Request Form on our website at: www.plantextractsinc.com/sales_service.php...
Need help?
Do you have a question about the H2EO and is the answer not in the manual?
Questions and answers