Table of Contents
Advertisement
Following are the solutions to problems that may occur during the installation and operation of the
Digisol DG-CH1130.
1) The DVR cannot boot up normally.
The power supply is not correct.
Switch power supply line is not in good connection/damaged.
The program updation is wrong.
The hard disk is damaged or the hard disk lines are broken.
The front panel is damaged.
The main board of the DVR is damaged.
2) The DVR reboots automatically or stops working after boot up.
The input voltage is not stable or too low.
The hard disk is damaged or the hard disk lines are broken.
The power of the switch power supply is low.
Video signal is not stable.
Bad heat radiator or too much dust or bad running circumstance for the DVR.
The hardware of the DVR is damaged.
3) System cannot detect the hard disk.
The hard disk power supply line is not connected.
The cables of the hard disk are damaged.
The hard disk is damaged.
The SATA port of main board is damaged.
This product comes with Two Years warranty. For further details about warranty
policy and Product Registration, please visit support section of
www.digisol.com
14
Advertisement
Table of Contents
