Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for FMC 872 Rack
- Page 1 MODEL 870/872 Rack Installation Guide/Parts Reference Form 5208...
- Page 2 INSTALL BOLSTER PLATE AND HARDWARE 1. Mount bolster plate to the hoist cylinder (single or double) using hardware supplied with the bolster kit. In most cases the bolt pattern in the top of the cylinder will determine how the bolster is to be oriented, however, the bolster plate for a single post type will usually be symmetrical.
- Page 3 INSTALL RUNWAYS 1. Locate the following hardware: NOTE: Part of loose parts pack 68289 QUANTITY PART NO. DESCRIPTION 1100073 Screw HHCS 3/4-10x2-1, 1100248 Lockwasher 3/4" 59683 Special Washer 2. Assemble runways to bolster plate(s) and level runways at the four points where the vehicles will rest (turntables should be set in the saddles).
- Page 4 Adjust the screws so that the distance between the edges of the runway rails is 38-1/4". It may be necessary to loosen the bolts attaching the runways to the bolster(s) so the runways can be moved in or out to achieve this dimension. Tighten bolster bolts and tie bar jam nuts when correct. INSTALL REAR APPROACH RAMPS AND RAMP EXTENSIONS 1.
- Page 5 ADJUST LEVELING LEGS 1 . Raise rack enough to clear leveling legs, and drop legs to full extension. Make sure all of them are locking in place. 2. Lower rack to alignment height, then adjust leg extensions to contact floor at correct rack level. Check level at 4 points (across turntables and front and rear).
Need help?
Do you have a question about the 872 Rack and is the answer not in the manual?
Questions and answers