Advertisement
Quick Links
Flyingwings ltd
Ninja Combat Slope Soarer
Flying wing
Thank you for purchasing the Ninja Slope Soarer
The word "Awesome" is over used, but this new glider lives
up to this. Firstly its big, at 48" with a deep chord , the Ninja
has a large wing area and will fly in winds form 10mph to gale force.
The Ninja will maintain inertia in collisions and aerobatics, successive loops are
possible and dynamic soaring is achievable.
Wingspan: 48 inches (1.2 metres)
As well as this power system you will require:
2 x servos 43g (standard size)
1 x Long range receiver
1 x Nihm 4.8v Battery 2500-3300mah
1 x Transmitter capable of elevon mixing or mixing module
CRITICAL DATA
CENTRE OF GRAVITY 220mm BACK
FROM THE NOSE POINT
TARGET FLYING WEIGHT
750-800 grams without Ballast
LETS GET BUILDING
BLACK AND LITE VERSIONS
HOT GLUE GUN
CA GLUE
UHU POR
Advertisement
Summary of Contents for Flyingwings ltd Ninja Combat Slope Soarer
- Page 1 Flyingwings ltd BLACK AND LITE VERSIONS Ninja Combat Slope Soarer Flying wing Thank you for purchasing the Ninja Slope Soarer The word "Awesome" is over used, but this new glider lives up to this. Firstly its big, at 48" with a deep chord , the Ninja has a large wing area and will fly in winds form 10mph to gale force.
- Page 2 Fibreglass or carbon spar STEP Approx 500mm Mark the centre of the spar with a marker. Squeeze some uhu por into the hole in the wing and insert the spar and twist to spread the glue out. Use uhu por glue to coat both faces of the wings insert spar and hold the wing together using some strapping tape.
- Page 3 STEP 60mm 100mm 50mm 170mm 70mm TOP OF WING 50mm 130mm Alternative servo location, may extension leads Above is a guide to the locations of the radio and battery equipment. These are only a guide and should be modified to suit your needs. Use a fairly big battery like a 3000mah 4.8v unit.
- Page 4 Covering the wing STEP Spray the underneath of the wing thoroughly using the spray glue then using the 50mm strapping tape, tape the underneath as shown, wrapping the overlapping tape over to the top, repeat the process for the top. STEP Coloured tape, Spray once more and cover the wing with the coloured tape starting from the back to the front with a 3mm overlap.
- Page 5 STEP Using 25mm strapping tape or cutting 50mm tape down the centre, attach the elevons. 1. Run a strip down the back edge of one side of the wing, half on half off, offer up the elevon at a downward angle as show, attach it to the tape. 2.
- Page 6 STEP Wingtips: Cut some stapping tape, and wrap it around the front section of the wingtip, top and bottom. Feed a strip through the slots and attach top & bottom. STEP Final Set up 1. Check the centre of gravity is 220mm back from the nose point 2.