ProForm PFTL69505.0 User Manual page 8

Proform user's manual treadmill
Table of Contents

Advertisement

5. See the inset drawing. Make sure that there are two U-
nuts (112) in the upper end of each Upright (119, 111).
Note: Extra U-nuts may be included.
Identify the Right Handrail (120) and the Left Handrail
(108); there is an identification sticker on each Handrail.
Hold the Right Handrail near the Right Upright (119).
Insert the Wire Harness (118) into the large hole in the
Right Handrail and out of the upper end as shown.
Next, hold the Right Handrail (120) against the Right
Upright (119). Tighten a 3/8" x 3 1/2" Bolt (121) three to
four turns into the Right Upright and the lower end of the
Right Handrail. Then, tighten two 5/16" x 1" Bolts (113)
into the upper end of the Right Handrail and the Right
Upright. Be careful not to drop the Bolts into the
Right Handrail. If necessary, raise or lower the Right
Handrail to thread the Bolts into the Right Upright. Firmly
tighten all three Bolts.
Attach the Left Handrail (108) to the Left Upright (111) as
described above. Note: There is not a wire harness in the
Left Upright.
6. Turn the Console (101) upside-down; be careful not to
scratch the Console. Remove the Console Back (104
[see drawing 7]) from the Console. If the four Pulse Bar
Screws (76) (only two are shown) are in the Console
Frame (80), remove them.
Hold the ends of the Pulse Bar (77) against the Console
Frame (80) as shown. Route the pulse wire in the Pulse
Bar under the Console Frame (80) as shown, and plug
the Pulse Wire into the indicated connector on the
Console (101). Next, attach the Pulse Bar to the Console
Frame with the four Pulse Bar Screws (76). Firmly
tighten the Pulse Bar Screws. Be careful not to dam-
age the wires.
Route the ground wires away from the indicated plastic
post on the Console (101). Attach the ends of the ground
wires to the Console Frame (80) with a 1/2" Screw (52).
Note: There are no wires on the other side of the Pulse
Bar (77).
7. Attach the Console Back (104) to the console assembly
with five 3/4" Screws (33). Be careful not to pinch any
wires.
5
113
108
121
6
Plastic
Post
80
Ground
Wires
Pulse
Wire
7
33
8
118
113
111
120
52
76
77
101
Connector
33
104
33
Console Assembly
119
112
119
121

Advertisement

Table of Contents
loading

This manual is also suitable for:

Crosswalk caliber ii

Table of Contents