Subscribe to Our Youtube Channel
Related Manuals for MTI Sanctuary Spa
Summary of Contents for MTI Sanctuary Spa
- Page 1 S A N C T U A R Y S P A O W N E R ’ S M A N U A L I N S T A L L A T I O N G U I D E Installer: this booklet must be given to ...
- Page 2 O W N E R ’ S M A N U A L A N D I N S T A L L A T I O N G U I D E Thank you for choosing the MTI Sanctuary Hydrotherapy Tub. You have purchased the best-built acrylic hydrotherapy tub in America.
- Page 3 O W N E R ’ S G U I D E A. PARTS AND FEATURES Shown with chrome filter spout and optional handheld shower with diverter. STANDARD FEATURES** 1. Air system control 8. Hand wand 2. On / Off control 9. Cable driven drain control* 3.
- Page 4 B. TUB USE The Sanctuary Hydrotherapy Tub is recommended for relaxing thermo-air baths and hydrother- apy massage baths. Use the air system to relax the body and prepare for further bodywork, use the point-massage jets to warm up the muscle tissues for deep tissue massages, and use the hand wand to perform lymphatic drainage and treatments.
- Page 5 HAND WAND NOTE: Fully submerge the head of the hand wand under water before turning on the pump. Failure to do so could cause water to spray around the room and may disturb the client. The massage hand wand is powered by the pump. When the pump is operating, a steady stream of water will flow through the hand wand hose. To adjust the pressure of the hand wand during operation, twist the handle located near the end of the hand wand. For extra deep pressure, close off each of the individual jets so that all water pressure is diverted to the hand wand.
- Page 6 To divert water from the faucet spout to the hand sprayer or vice versa, push the diverter knob. The sprayer may be adjusted to different settings by twisting the showerhead. The handheld sprayer is a useful tool to help rinse the tub off after cleaning. C. TUB CARE AND CLEANING CLEANING YOUR TUB After each use, MTI recommends first turning on the...
- Page 7 Remove dust and dry dirt with a soft, damp cloth. Clean grease, oil, paint or ink stains with isopropyl (rubbing) alcohol. Dry with a clean, soft cloth. Avoid using razor blades or other sharp objects that might scratch the surface. Small scratches can be removed by applying a thin coat of automotive paste wax and buffing lightly with a clean cloth.
- Page 8 I N S T A L L A T I O N G U I D E Read all requirements and instructions before installing the tub ½ Floor location for Incoming Hot and Cold Water Lines Blower Floor location for Electrical Supply Lines Pump A. REQUIREMENTS LOCATION REQUIREMENTS...
- Page 9 Every MTI Whirlpool is supplied with a 29” grounded plug to be plugged into a standard grounded receptacle. Do not remove this plug. If a wall mount switch is desired to control use of the unit, the switch should control the receptacle. Under no circumstance should you alter the provided supply cord.
- Page 10 Your new MTI hydrotherapy tub is ready for turnkey installation. The pre-leveled frame assures that the tub will be of uniform height; the high-density foam used to protect the air system also functions as a bedding compound; and the removable skirting provides pump and blower access.
- Page 11 4. Check to be sure that you have all of your tools. 5. Dispose of/recycle all packaging materials. 6. Check to be sure that the water faucets are working. 7. Check for leaks around the faucet and the drain. 8. Use a mild solution of liquid household cleaner and warm water to remove waxy residue caused by the protective shipping material.
- Page 12 LITTLE OR NO ACTION FROM THE JETS • Open air volume control to allow air to mix with water. • Check each jet to assure that they are all set to the open position by twisting the inner eye- ball of the jet. Note: Each jet may be shut off individually. LED LIGHT NOT WORKING •...
- Page 13 A T T E N T I O N I N S T A L L E R ! ! ! This whirlpool tub was water tested at the factory and found to be fully operational and leak free prior to shipping. Freight handling and job site exposure may have deteriorated the tub’s condition.
- Page 14 Return of Warranty Card: The warranty registration card must be filled out by the purchaser within one hundred twenty days from purchase and mailed to MTI Whirlpools in order for this warranty to take effect. Warranty registration can also be done online at mtiwhirlpools.com. Warranty Limitations: ...
- Page 15 MTI Whirlpools is NOT liable for incidental or consequential damage, loss of time, inconvenience, incidental expenses or material charges or any other costs related to the application of this warranty. We do not cover the following: careless handling; modification of any type for any reason; improper installation (See Installation Instructions); connections supplied by the installer; improper voltage supply/electrical modifications;...
- Page 16 Manufactured by: MTI Whirlpools, Inc. mtiwhirlpools.com 670 N. Price Road Sugar Hill, GA 30518 800 783 8827 770 271 8228 Fax 800 438 8827 © Copyright 2010 by MTI Whirlpools, Inc. Modification Rights Reserved. 0410...
Need help?
Do you have a question about the Sanctuary Spa and is the answer not in the manual?
Questions and answers