Summary of Contents for Skutt KilnLink
- Page 1 KilnLink Installation Manual 6441 SE JOHNSON CREEK BLVD. PORTLAND, OR 97206 (503) 774-6000 SKUTT@SKUTT.COM WWW.SKUTT.COM Rev. 1/15/18...
-
Page 2: Specifications
• Current firmware in controller. Guaranteed with purchase of kiln manufactured after 7/19/2012. * This looks likes a standard phone cord, but it is different. Use only cords supplied by Skutt. Required by Customer for Installation • Internet Connection (always on) •... - Page 3 14 ft. cable will reach between the KilnLink Box and the control box on the kiln, or so that the KilnLink Box is within a 14 ft. cable reach of a 3-way splitter and the 3-way spliter is within a 14 ft. cable reach of the control box on the kiln.
- Page 4 Setting the ID If you are connecting more than one kiln to your KilnLink Box (you can connect up to four), you will need to have a unique ID for each kiln. All new kilns will leave the factory with a Kiln ID set to “1”.
- Page 5 City _________________________ State ______ Zip __________ Phone __________ Primary User (Administrator) Information Name ____________________________________ Phone ___________________________________ Email ___________________________________ Email this form to kilnlink@skutt.com or fax it to (503) 774-7833. You may also provide it to your distributor to forward on to Skutt.
- Page 6 You should have received a temporary User Name and Password when you received the KilnLink Box. If you did not, you will need to contact your Skutt distributor and give them the following information: •...
- Page 7 KilnLink...
- Page 8 KilnLink...
Need help?
Do you have a question about the KilnLink and is the answer not in the manual?
Questions and answers