Table of Contents
Advertisement
MVD1000 Series
Radar Vehicle Detector
Handbook & Installation Guide
Ó
Copyright
This document is the exclusive property of Clark Systems Limited. It may not be copied or reproduced on any media without the express
written permission of the Managing Director.
The contents are for information purposes only and do not form any part of any
Contractual agreement between Clark Systems Limited and any third party unless so specified. Failure to comply shall result in
litigation of the perpetrator under the Copyrights Act.
S00104101MVDHandbook.doc
1
July 2002
Advertisement
Table of Contents
Summary of Contents for Clark Systems MVD1001
- Page 1 Ó Copyright This document is the exclusive property of Clark Systems Limited. It may not be copied or reproduced on any media without the express written permission of the Managing Director. The contents are for information purposes only and do not form any part of any Contractual agreement between Clark Systems Limited and any third party unless so specified.
- Page 2 This Page Left Intentionally Blank S00104101MVDHandbook.doc July 2002...
- Page 3 Contents Description .......................... 4 Installation Instructions......................5 Switch setting ........................5 Range selection....................... 5 Mode selection ........................ 6 Mounting ..........................6 Tilt adjustment ......................... 7 Pan adjustment........................ 7 Connections ........................8 Commissioning........................8 Problem Sites........................8 Repair & Maintenance......................8 Specifications ........................
-
Page 4: Description
FEATURES • Precise, selectable, detection range using RADAR techniques. • Selectable Low-Speed Threshold • Detection of approaching, receding or bi- directional traffic • Lightweight, compact unit • Advanced microprocessor controlled signal processing • Easy Installation • Two Lane Coverage Photograph 1 - •... -
Page 5: Installation Instructions
Installation Instructions Switch setting Switches should preferably be set BEFORE mounting on signal head. Access to the switches is gained by removing the appropriate weatherproof plug, see Photograph 2. Ensure that the plugs are replaced and securely tightened after setting the switches. Photograph 2 - Rear View of Detector Access to Range Switch... -
Page 6: Mode Selection
Mode selection Detectors are normally supplied set to detect approaching vehicles travelling at speeds greater than the threshold of 8.5 Km/Hr (position 0). This is the normal operating mode. Other modes are available as shown in Table 2 which may be selected according to local traffic engineering requirements. -
Page 7: Tilt Adjustment
Note: This diagram illustrates the layout for vehicles driving on the left- hand side of the road (as in UK). For right-hand side diagram should be 'mirrored'). Detector Single Lane Two Lane Type MVD1001 Table 3 - Pan-Angle Specifications S00104101MVDHandbook.doc July 2002... -
Page 8: Connections
Pedestrian activity can also cause problems, particularly where a low threshold speed has been selected. All radio frequency detectors suffer from these and similar problems. Clark Systems’ detectors are designed to provide substantial immunity from these problems, but in common with all detectors, detection cannot always be guaranteed. -
Page 9: Specifications
Operating Voltage: 24 +20% AC/DC 12 +20% AC/DC Contact Details An accessory transformer for mains use (230/115 V) is available. Clark Systems Limited PO Box 182 Range Selection: Hedge End SO30 2PL Range is selected by means of a rotary switch accessible via a weatherproof plug.
Need help?
Do you have a question about the MVD1001 and is the answer not in the manual?
Questions and answers