ProForm 831.298060 User Manual page 8

CONSOLE DIAGRAM
Displays
Key
BATTERY INSTALLATION
The console requires three "AA" batteries (not in-
cluded). Alkaline batteries are recommended. Open
the battery cover as shown below. Insert three batter-
ies into the battery compartment, making sure that the
negative (Ð) ends of the batteries are touching the
springs in the battery compartment. Close the bat-
tery cover, push up on the battery cover tab, and then
push the tab forward as shown. Be sure that the tab
locks into place.
Battery
Cover
Batteries
Speed Control
Clip
Battery
Cover Tab
8
Before operating the
console, read the following
precautions.
¥ Do not stand on the walk-
¥ Always wear the clip (see
¥ Adjust the speed in small
¥ The training zones marked
¥ To reduce the possibility
STEP BY STEP CONSOLE OPERATION
If there is a thin sheet of clear plastic on the face of the
console, remove it.
Before operating the console, make sure that the
power cord is properly plugged in. (See HOW TO
PLUG IN THE POWER CORD on page 7.)
Next, step onto the foot rails of the treadmill. Find the
clip attached to the key (see the drawing above), and
slide the clip onto the waistband of your clothing.
Follow the steps on page 9 to operate the console.
CAUTION:
ing belt when turning on
the power.
the drawing at the left)
while using the treadmill.
When the key is removed
from the console, the
walking belt will stop.
increments.
beside the speed control
are general guidelines
only. See page 14 for
more information.
of electric shock, keep the
console dry. Avoid
spilling liquids on the con-
sole and use only a seal-
able water bottle.