Specifications - RIDGID 975 Manual

The 975 Combo Roll Groover is a portable unit intended
for occasional use on the job site and should not be used
for high volume work or for production work in a pipe fab-
rication shop.
When properly used, the Model 975 Combo
NOTICE
Roll Groover makes grooves 2" - 6" that are dimensionally
within the specifications of AWWA C606-06. Selection
of appropriate materials and joining methods is the respon-
sibility of the system designer and/or installer. Before any
installation is attempted, careful evaluation of the specific
service environment, including chemical environment and
service temperature, should be completed.

Specifications

Capacity ........................1
(See Table II for Wall Thickness)
Groove Diameter
Adjustment ....................Adjusting Screw And Groove
Actuation .......................Feed Screw with
Power Drive Mounting ...RIDGID 300 Power Drive (38
Weight............................27.6 lbs.
The 975 Combo Roll Groover is protected under U.S. and
International patents, including patents 6,272,895 and
6,591,652.
Slide Block
Groove Roll Shaft
Groove Roll
Drive Shaft
Cover Plate
Ratchet
Figure 1 – 975 Combo Roll Groover
Find Quality Products Online at:
1 / " – 6" Schedule 10 and
4
Schedule 40 Steel Pipe
With Roll Change: 2"- 8" Cop -
per Tube, Type K, L ,M & DWV
Depth Gauge
1 / " Ratchet
2
Wrench
and 57 RPM Model Only)
RIDGID 300 Compact Thread -
ing Machine (with adapter)
Feedscrew
Adjusting Screw
Groove Depth
Gauge
Support Arm
Base
Extension
GlobalTestSupply
Ridge Tool Company
www.
975 Combo Roll Groover
Standard Equipment
1 1 / " – 6" Schedule 10 & 40 Groove and Drive Rolls
4
Ratchet Wrench ( 1 / " Drive) with Button Release
2
Locking Extension Drive
Support Arms
Integral Index Depth Gauge
Roll Groover Inspection
WARNING
Before each use, inspect your roll groover and
correct any problems to reduce the risk of serious
injury from crushing injuries and other causes and
prevent roll groover damage.
Do not use this roll groover with a power drive/ -
thread ing machine that does not have a foot switch.
1. If the roll groover is installed on a power drive or
threading machine, make sure that the machine is
unplugged and that the REV/OFF/FOR switch is in the
OFF position. Inspect and maintain the power drive/ -
thread ing machine as directed in the machine's oper-
ator's manual. Failure to properly inspect and maintain
equipment can result in serious injury and property
damage. Make sure that that a foot switch is present
and properly operating. Do not use this roll groover
without a foot switch.
2. Clean any oil, grease or dirt from the roll groover,
including the carry handle, and the ratchet used to
activate the roll groover. This reduces the risk of
injury due to the groover or ratchet slipping from your
grip during use and allows easier inspection.
3. Make sure that the support arms are tight in the body
of the roll groover.
4. Inspect the roll groover for any broken, missing, mis-
arranged or binding parts or any other condition that
may prevent the safe and normal operation. Make
sure that the groove roll and drive shaft turn freely.
5. Check that the warning label is present and firmly
attached. See Figure 2 for the location of the warning
label.
6. If the drive shaft knurls are dirty, clean with a wire
brush. Dirty knurls can cause pipe slippage and track-
ing issues during grooving.
.com
sales@GlobalTestSupply.com
5