Advertisement
Quick Links
Advertisement
Related Manuals for Daytime BC16
Summary of Contents for Daytime BC16
- Page 1 Operating Manual Basic Control BC16 single-channel for matrix...
- Page 2 We would be happy to answer any questions that you may have. ® The entire team at WALTRON wishes you a "bright" future with our daytime lighting! Notice, warning and safety symbols The European Standard prescribes the use of the following symbols for specific situations; they are not intended to unsettle the user.
- Page 3 WALTRON recommends making "drip loops" in ® repaired, either by an authorized daytime service the converter cables to prevent water partner or directly by the manufacturer. (condensation) from running along the cable to the converter or outlet.
- Page 4 Scope of delivery 1 lighting controller: Basic Control BC16 single-channel for matrix 1 operating manual Features & functions • Sunrise and sunset – simulating natural lighting conditions for day and night • Easy to operate and program: directly at the device, using three buttons and a status LED •...
- Page 5 Overview The Basic Control BC16 lighting controller is designed for operating the "matrix" LED lights, with a total output of max. 240 watts (24 matrix modules each at 10 watts). It can switch between day and the night lighting, and has a consistent dimming function (sunrise/sunset). The brightness for the day or night lighting has a stepless adjustment which can then be saved.
- Page 6 240 watts: ® Example with one converter, one two-way distributor (optionally available), and two daytime matrix lights, with a total output of max. 240 watts: 2. Plug in the mains power plug or switch on the power supply / supplies.
- Page 7 3. Setting the clock: The time can be set at any time using the buttons. The hour can be adjusted hour-by-hour and the minutes can be adjusted in 5-minute increments. The time is set as follows: 1. Press the S1 button and hold down for max. 5 second a.
- Page 8 5. Setting the brightness of daylight and night light: Press the S2 and S3 buttons at the same time. The status LED will illuminate red. First, daylight is activated; it can be dimmed using the S2 and S3 buttons. The connected light will blink once the maximum value is reached.
- Page 9 9. Time-lapse function (special mode): The BC16 has a time-lapse mode that can be used for testing purposes or for checking your specified values. When it is enabled, the clock runs several times faster and shows the specified light program in fast motion in 60 seconds.
- Page 10 10. Brief overview of the settings Setting Procedure Time Press and hold S1. Select the hour with S2 and the minutes with S3 (in 5-minute increments). for example: 20:15: press S2 20 times (= 20:xx); press S3 3 times (= XX:15) Always set the hours before setting the minutes, since the minute value is set to 00 after the hours are set! Your settings will be saved automatically after a short interval of no pressed buttons.
- Page 11 11. Technical specifications Dimensions L/W/H (without connecting cables): 90 x 40 x 26 mm Length of connecting cables (primary / secondary): approx. 90 mm (including plug and socket) Weight: approx. 80 g Operating voltage: 24 VDC (safety extra low voltage) Max.
- Page 12 Warranty notice We have a 24 month warranty for daytime® products that we deliver within the EU. Exceptions are damages due to non-compliance with the operating manual or other improper handling. If, contrary to expectations, you have grounds for a complaint within this warranty period, please ®...