L.B. White Guardian Installation Instructions

Flame sensor kit

Download this manual

View these instructions online at www.lbwhite.com

Kit Contents:

DESCRIPTION

Flame Sensor

Heat Shrink Tube

1/4" Male Quick Connect Terminal

Mounting Hardware

Installation Instructions

Qualifications for installation of the kit:

• You must be able to read and understand these instructions.

• You must be properly trained and have sufﬁ cient experience to install the kits.

• You must be able to test the heater for proper operation and place the heater in a

continuing safe and normal operating condition.

Discussion:

• Use this kit to maintain corrosion resistance of the electrical connection when replacing the ﬂ ame sensor.

• Depending on the service kit, not all the parts may be use.

Initial Preparation:

• Disconnect the heater from its electrical supply.

• Close all fuel supply valves to the heater.

• Open the heater's access door at the gas inlet end of the heater.

WORLD PROVIDER - INNOVATIVE HEATING SOLUTIONS

411 Mason Street, Onalaska, WI 54650 • 800-345-7200 • 608-783-5691 • 608-783-6115 (fax) • www.lbwhite.com

INSTALLATION INSTRUCTIONS

Flame Sensor Kit

QTY.

Tools required:

- 5/16 nut driver or standard screwdriver

- Wire cutting/stripper/crimping tool

- Heat gun, small hand-held torch, or butane lighter

Guardian

Do you have a question about the Guardian and is the answer not in the manual?

Page 1: Kit Contents
INSTALLATION INSTRUCTIONS Guardian Flame Sensor Kit View these instructions online at www.lbwhite.com Kit Contents: DESCRIPTION QTY. Tools required: Flame Sensor - 5/16 nut driver or standard screwdriver Heat Shrink Tube - Wire cutting/stripper/crimping tool 1/4” Male Quick Connect Terminal - Heat gun, small hand-held torch, or butane lighter...
Page 2 If the replacement ﬂ ame sensor end terminal 1/4 in. male is of a different terminal, proceed to step 4. quick connect 3. For Guardian 250, skip to step 6. 6. Securely mount the replacement sensor to its bracket, using the provided kit’s hardware. FIG. 2 7.
Page 3 Guardian Flame Sensor Kit FIG. 5 FIG. 6 1/2 to 3/4 in. Heat shrink tube Burner Flame Flame Sensor Flame sensor connector Burner Casting 6. Keep these instructions for future use. Purple wire B. Completion 1. Secure any excess of wire using the purse lock clip.
Page 4 Service Contact your local L.B. White dealer for replacement parts and service. You may also call the L.B. White Co., Inc. at 1-800-345-7200, for assistance, or email us at customerservice@lbwhite.com. Be sure that you have your heater model number and conﬁ...