Summary of Contents for LinkSprite LS-Y201
- Page 1 Step-by-Step Tutorial for Using LinkSprite JPEG Color Camera Serial UART Interface Model LS-Y201 Page 1 of 8...
- Page 2 Hardware needed 1. The camera itself 2. 5V power supply 3. RS232 Cable with DB9 female connector Hardware connection TXD(out) of camera is connected to pin 2 (RXD) of the DE-9 FEMALE. RXD(in) of camera is connected to pin 3 (TXD) of the DE-9 FEMALE. GND of camera is connected to pin 5 (GND) of the DE-9 FEMALE, and also connected to GND of Power.
- Page 3 A photo of setup: Software Needed X-CTU from digi.com Evaluation Utility: http://www.linksprite.com/download/showdownload.php?id=36&lang=en Test Procedure Step 1: Sanity Check Power On Reset. X-CTU shows reset message: Page 3 of 8...
- Page 4 Step 2: Launch the evaluation GUI Page 4 of 8...
- Page 5 Click “Open” under the COM/Data Rate Section. Modify the path for capture files. Note: this is a must. If the path is pointing to an invalid or unwritable location, the program may crash. Step 3-a: Take picture with the evaluation GUI Page 5 of 8...
- Page 6 Click “Single Shot”: Page 6 of 8...
- Page 7 Step 3-b: Take picture with X-CTU Compose command in HEX (refer to use manual) and Send data. X-CTU will show the command you just send and the Camera’s returned message. Take Picture command: Page 7 of 8...
- Page 8 LinkSprite Technologies, Inc. Add: 1410 Cannon Mountain Dr, Longmont, CO 80503 Tel: 720-204-8599 Email: sales@linksprite.com support@linksprite.com Technical support: www.linksprite.com Web: Page 8 of 8...
Need help?
Do you have a question about the LS-Y201 and is the answer not in the manual?
Questions and answers