Chicago Pneumatic TR 630 Safety And Operating Instructions Manual

Trench compactor

Hide thumbs

Table Of Contents

Table of Contents

Quick Links

Safety and operating instructions

Trench compactor

TR 630, 850

www.cp.com

Table of Contents

Summary of Contents for Chicago Pneumatic TR 630

Page 1 Safety and operating instructions Trench compactor TR 630, 850 www.cp.com...
Page 2 TR 630, 850 9800 1262 01a | Original instructions...
Page 3 TR 630, 850 Contents Contents Introduction............... 5 About the Safety and operating instructions.
Page 4 Contents TR 630, 850 Uncertainties, sound value............32 Dimensions.
Page 5: Introduction
TR 630, 850 Safety and operating instructions Introduction Thank you for choosing Chicago Pneumatic brand products. For over a century, the Chicago Pneumatic brand has represented performance and innovation in the pneumatic tool industry. Today the brand is found around the world on a range of pneumatic and hydraulic tools that includes breakers, rock drills, chipping hammers, clay-diggers, picks and busters, scabblers, pumps and a whole lot more.
Page 6: Safety Instructions
Safety and operating instructions TR 630, 850 > Appropriate work overall or similar clothing (not Safety instructions loose-fitting) that covers your arms and legs. To reduce the risk of serious injury or death to Drugs, alcohol or medication yourself or others, read and understand the Safety...
Page 7 TR 630, 850 Safety and operating instructions ► Never overfill the fuel tank. WARNING System error hazard Errors in the system can cause injury. If any error Make sure the filler cap is screwed on when the ► occurs in the system: machine is used.
Page 8 Safety and operating instructions TR 630, 850 ► Operate and maintain the machine as WARNING Battery hazard recommended in the operating and safety The battery contains poisonous and corrosive instructions sulphuric acid and can explode, this can cause injury. ►...
Page 9 TR 630, 850 Safety and operating instructions ► Immediately stop working if the machine WARNING Motion hazards suddenly starts to vibrate strongly. Before When using the machine to perform work-related resuming the work, find and remove the cause of activities, you may experience discomfort in the the increased vibrations.
Page 10: Transport, Precautions
Safety and operating instructions TR 630, 850 WARNING Noise hazard CAUTION High temperature High noise levels can cause permanent and disabling The machine's front cover, exhaust pipe, and hearing loss and other problems such as tinnitus hydraulic system become hot during operation.
Page 11: Overview
TR 630, 850 Safety and operating instructions Scraper Overview Engine oil filter To reduce the risk of serious injury or death Fuel filter to yourself or others, read the Safety instructions section found on the previous pages of this manual before operating the machine.
Page 12: Labels
Safety and operating instructions TR 630, 850 Transmitter Horn Start/Stop switch, engine Atlas Copco Construction Tools AB Indicator for low battery voltage 105 23 Stockholm, Sweden Type Operating mass kg Rated power kW Year of Mfg roduct dentification umber Made in Sweden...
Page 13 TR 630, 850 Safety and operating instructions Noise level label Hot surfaces in the engine compartment. Keep your hands at a safe distance from the danger zone. Diesel Battery disconnector label The label indicates the guaranteed noise level corresponding to EC-directive 2000/14/EC. See "Technical data"...
Page 14: Transport
Safety and operating instructions TR 630, 850 Securing point label ► Check the machine's data plate for information of the weight. Lifting the machine Before lifting the machine check that the shock ♦ absorbers (A) and safety frame lifting point (B) are Use ear protectors label correctly attached and not damaged.
Page 15: Installation
TR 630, 850 Safety and operating instructions Installation Operation WARNING Engine running hazard Fuel Vibrations from the engine can cause material changes, this can cause the machine to move and Filling cause injuries. Never leave the machine with the engine running.
Page 16: Receiver
Safety and operating instructions TR 630, 850 ♦ Two 1500 mAh NiMh batteries are supplied with ♦ The battery must be trickle-charged every four the machine on delivery. The extra battery can be weeks, if the transmitter is not used. Remove the charged in the battery charger during operation.
Page 17: Antenna
TR 630, 850 Safety and operating instructions The receiver provides indications, visible from When pairing has been successfully accomplished, outside, to show that the receiver is in pairing mode restart the transmitter. Restart the reciever by and that the transmitter has successfully been paired pressing the stop knob.
Page 18: Operating On Slopes
Safety and operating instructions TR 630, 850 ♦ The tilting angle is measured on a hard level surface with the machine stationary. Vibration switched OFF and all tanks full. 20° Operating on slopes WARNING Slope hazards During operation, secure the machine so it can not Start and stop fall if it is placed on a sloping ground.
Page 19 TR 630, 850 Safety and operating instructions 1. Check the engine oil level. NOTICE If the charging symbol and oil pressure symbol do not extinguish, the machine must be shut off. Fault tracing and repair must be performed by authorized service personnel before the machine is started again.
Page 20 Safety and operating instructions TR 630, 850 Symbol Description Radio contact established between transmitter and receiver. Alarm, charging. Alarm, low oil pressure. System information When the transmitter is turned on, the following Fault codes: 05: Tilt switch activated. data will be shown on the display: The front switch is located behind the engine on the right side of the machine.
Page 21: Operating
TR 630, 850 Safety and operating instructions 5. Push the start/stop switch (D) back. The buzzer The machine can be operated by cable control. (E) sounds when the engine stops. Mount the cable on the machine. ♦ Mount the cable on the transmitter.
Page 22: Control
Safety and operating instructions TR 630, 850 Operation Control The machine must always be operated at the highest engine revs when vibration is used, the engine revs switch (A) is then in position +. Speed switch (B) must be in the position for low speed.
Page 23: When Taking A Break
TR 630, 850 Safety and operating instructions To operate the machine when both of the contact to trickle charging (13.3 V) when the battery is fully sensors are activated, press and hold the horn button charged. for more than 1 second. Hold the button while Battery storage and trickle charging operating with the joystick.
Page 24: Fuses
Safety and operating instructions TR 630, 850 ♦ Check and replenish engine oil. See engine LED indicator Battery status manual for more information. Yellow Battery verification Orange Fast charge ♦ Check and replenish fuel. Green with intermittent yellow Top-off charge flash Check for oil leaks.
Page 25 TR 630, 850 Safety and operating instructions Cleaning dust extractor valve Checking hydraulic oil level Check air intake. Clean if necessary Wipe off the oil level gauge (A). ♦ ♦ Check dust extractor valve (A) for free flow. ♦ remove any blockages by pressing together.
Page 26: After The First 20 Hours Of Operation
Safety and operating instructions TR 630, 850 Cleaning the machine 1. Unscrew the drain plug (A) on the draining hose and drain off all the oil. Use a container with at Do not spray water directly onto electrical ♦ least a 2.5 litre capacity.
Page 27: Every 250 Hours Of Operation (Every Month)
TR 630, 850 Safety and operating instructions Hydraulic system, replacing the oil filter Diesel engine, replacing the fuel filter 1. Clean the area around the filter cover and then 1. The replacement intervals for fuel filters depend unscrew the cover (A). Replace the filter element.
Page 28: Inspection And Cleaning Of The Engine Air Cooling System
Safety and operating instructions TR 630, 850 7. Clean or replace the cartridge. 4. Pump with the hand pump (C) until the fuel is free from air. Tighten the bleeding screw (B). 8. Assemble in reverse order. Check the seal insert of the collar nut (D).
Page 29: Every 500 Hours Of Operation (Yearly)
TR 630, 850 Safety and operating instructions Every 500 hours of Disposal operation (yearly) A used machine must be treated and disposed of in such a way that the greatest possible portion of the Maintenance routines: material can be recycled and any negative influence...
Page 30: Technical Data
Safety and operating instructions TR 630, 850 Technical data Machine data TR 630, TR 850 Hatz Engine Type Hatz 2G40, 2-cylinder Diesel Power kW (hp) 12.5 (17.5) Rated speed r.p.m. 2,500 Cooling system Air cooled + hydraulic oil cooler + fan...
Page 31: Weights
TR 630, 850 Safety and operating instructions Weights TR 630 TR 850 Net weight, kg (lbs) 1,548 (3,413) 1,650 (3,638) Operating weight EN500, kg (lbs) 1,573 (3,468) 1,675 (3,693) Radio equipment Transmitter Operating voltage Battery NiMh 1500 mAh. The transmitter can be operated without battery via cable control.
Page 32: Noise And Vibration Data
Type at operator's ear dB(A) rel 1pW rel 1pW hours/day TR 630, TR 850 Uncertainties, sound value Uncertainties, sound value dB(A) dB(A) Type TR 630, TR 850 1.5-2.5 2.5-3.0 Uncertainty factor for gravel bed.
Page 33: Dimensions
TR 630, 850 Safety and operating instructions Dimensions mm (in.) 850 (33.5) 535 (21.1) 1385 (54.5) 2330 (91.7) 630 (24.8) 630 (24.8) 405 (15.9) 295 (11.6) 850 (33.5) 630 (24.8) 9800 1262 01a | Original instructions...
Page 34: Ec Declaration Of Conformity
EC Directive 2006/42/EC (Machinery Directive) and 2000/14/EC (Noise Directive), and the harmonised standards mentioned below. Guaranteed sound power level Measured sound power level Trench compactor [dB(A)] [dB(A)] TR 850, TR 630 Following harmonised standards were applied: EN500-1:2006+A1:2009 ♦ EN500-4:2006+A1:2009 ♦ EN13309:2000/prEN13309:2008 ♦...
Page 35 TR 630, 850 9800 1262 01a | Original instructions...

This manual is also suitable for:

Tr 850