Advertisement
• Use the slide switch located inside the battery compartment to
select either channel 1 or channel 2 for the RF transmission.
Remember which channel you select, as the receiver switch will need
to be set to the same channel number a little later.
• Insert the two AAA batteries (included) into the compartment.
Follow the polarity signs (+ and -) in the battery compartment so the
batteries face the correct direction.
• Replace the battery compartment cover by first inserting the two
bottom tabs into their holes and lightly pressing down.
Step 2: Set up the Receiver
• Turn the receiver over and find the RF channel slide switch. Select
the same channel, either channel 1 or channel 2, that you selected
on the mouse before you inserted the batteries.
Bottom View of Receiver
• To connect using a PS/2 Mouse Port:
o Attach the included green PS/2 adapter to the end of the
receiver cable.
o Turn your computer off.
o Connect the receiver to the PC by plugging in the green PS/2
connector at the end of the receiver to the mouse port of the
computer.
Channel Switch
Slide Switch Setting of Receiver
Advertisement
