Kenmore 790.3223 series Use & Care Manual page 8

Setting Surface Controls
Figure 1 (30" models)
OFF
LEFT
REAR
OFF
LEFT
FRONT
Figure 2 (36" models)
Figure 2
NOTE
In the event of an electrical power outage, the surface burners can be lit manually. To light a surface burner, hold a lit
match to the burner head, then slowly turn the surface control knob to LITE. After burner lights turn the knob to desired
setting. Use caution when lighting surface burners manually. Surface burner in use when an electrical power failure occurs
will continue to operate normally.
Do not place plastic items such as salt and pepper shakers, spoon holders or plastic wrappings
on top of the range when it is in use. These items could melt or ignite. Potholders, towels or wood spoons could
catch fire if placed too close to a flame.
Do not operate the burner for an extended period of time without cookware on the grate. The finish on
the grate may chip without cookware to absorb the heat.
OFF
RIGHT
REAR
OFF
LEFT
REAR
OFF
LEFT
FRONT
OFF
RIGHT
FRONT
OFF OFF
CENTE R RIGHT
REAR REAR
OFF
RIGHT
FRONT
Operating the Gas Surface Controls:
1. Place cooking utensil on surface burner.
2. Push the surface control knob down and turn counterclockwise out of the OFF
position.
3. Release the knob and rotate to the LITE position (see figure 2). Note: All four
electronic surface ignitors will spark at the same time. However, only the burner
you are turning on will ignite.
4. Visually check that the burner has a flame.
5. Turn the control knob counterclockwise to the desired flame size. The control
knobs do not have to be set at a particular setting. Use the knob indicator settings
to adjust the flame as needed. DO NOT cook with the surface control knob in the
LITE position. (The electronic ignitor will continue to spark if the knob is left in the
LITE position.)
Control Locations of the Gas Surface Burners
Your cooktop is equipped with gas surface burners with 3
different BTU ratings. The ability to heat food quicker and in
larger volumes increases as the burner size increases.
The small SIMMER burner is best used for simmering
delicate sauces, etc. This burner is located at the right rear
burner position on the cooktop.
The STANDARD burners can be used for most surface
cooking needs. The 2 (or 3 on 36" models) burners are
located at the left front and rear burner positions on the
cooktop. For 36" models the third standard burner is located
in the center rear position.
The POWER burner is best used for bringing large quantities
of liquid rapidly up to temperature or when preparing larger
quantities of food. The POWER burner is located at the right
front burner position on the cooktop.
Regardless of size, always select cookware that is suitable
for the amount and type of food being prepared. Select a
burner and flame size appropriate to the pan. Never allow
flames to extend beyond the outer edge of the pan.
8