Do you have a question about the CLM-194 and is the answer not in the manual?
Questions and answers
Summary of Contents for Eoptis CLM-194
Page 1
CLM-194 Digital handheld colorimeter User Guide Rev. 1.05 - 06/2014...
Page 2
Eoptis customers using or selling these products for use in such applications do so at their own risk and agree to fully indemnify Eoptis for any damages resulting from such improper use or sale.
User Guide VERVIEW Thank you for purchasing the Eoptis' CLM-194, a handheld digital tristimulus colorimeter. The CLM-194 is a handheld compact device for colorimetric detection with a reliability higher than human eye and at a competitive price. Colour measurements can be performed on the surface of a wide range of matte and glossy materials, thanks to a (45°c:0°) measurement geometry and the very uniform illumination provided by integrated LEDs.
EASUREMENT EOMETRY The CLM-194 colorimeter is designed to measure the samples the way the human eye does in the real world. It implements a (45°c:0°) geometry, that uses 45° circumferential illumination by means of multiple directional sources and 0° viewing perpendicular to the sample plane, according to ASTM E 1164. The circumferential illumination is essential to achieve repeatable measurements on directional and structured surfaces.
Page 8
Several published standards address sample selection for various industries (fibers, yarn, liquids, powders, coatings, paints, papers, leather, etc...). Contact Eoptis for additional information and support in identifying the best technique to exploits the full performance of the colorimeter.
Page 9
At the end of the software and driver setup, plug the USB cable into a free USB machine’s USB 2.0 port port of the PC. The red EOPTIS logo indicator on the colorimeter will illuminate. confirm successful installation If not, check the Troubleshooting section.
CIE1931-2° and CIE1964-10° standard colorimetric observers Short-term repeatability 0.03E* typ - D65/2°, standard deviation of 30 measurements every 5 s on white reference standard under Eoptis standard conditions (*) Illumination/Measurement area Ø10mm /Ø18mm Size of smallest measurable specimen Ø23mm flat surface Measurement time <0.1 s, with 5 s minimum recommended measurement interval...
This is due to several factors (such as the ambient light, monitor calibration, gamma settings) which must be controlled and fine tuned in order for the colours to match. Contact Eoptis to check how your PC can be tuned to improve matching.
(1) year from shipment date. Should a unit fail during this period, Eoptis will, at its option, repair or replace the damaged unit. Repaired or replaced units will be covered for the remainder of the original equipment warranty period.
Need help?
Do you have a question about the CLM-194 and is the answer not in the manual?
Questions and answers