Download Print this page

Centeron CGW Series Instruction Manual

Advertisement

Quick Links

Notice
The information contained in this document is current as of the date of publication
but is subject to change without notice. The manufacturer makes no warranty,
expressed or implied, with regard to this material, including but not limited to
the implied warranties of merchantability and fitness for a particular purpose.
The manufacturer shall not be liable for errors contained herein or for incidental or
consequential damages in connection with the furnishing, performance, or use of
this material.
The manufacturer assumes no responsibility for the use or reliability of its products
or equipment other than that for which it is intended or for use other than in the
manner prescribed herein.
This document is protected by copyright. All rights reserved. No part of this
document may be reproduced, copied, photographed, electronically scanned, or
translated into another language without the prior written consent of the
manufacturer.
Other manufacturer or service names mentioned in this publication are trademarks,
Gateway
service marks, or registered trademarks of their respective holders.
All Rights Reserved.
Instruction Manual
Model: CGW Series
Document: 040214B0001
Revision: C
Dated: 28 January 2015

Advertisement

loading
Need help?

Need help?

Do you have a question about the CGW Series and is the answer not in the manual?

Questions and answers

Eugene Anthony Dermody
May 12, 2025

cgw452 configure port forwarding

1 comments:
Mr. Anderson
May 21, 2025

Port forwarding is not required or supported on the Centeron CGW Series CGW452. The Gateway connects only to the Data Center, and no inbound port forwarding rules should be set on the customer’s network firewall.

This answer is automatically generated

Summary of Contents for Centeron CGW Series

  • Page 1 Other manufacturer or service names mentioned in this publication are trademarks, Gateway service marks, or registered trademarks of their respective holders. All Rights Reserved. Instruction Manual Model: CGW Series Document: 040214B0001 Revision: C Dated: 28 January 2015...
  • Page 2 Gateway Instruction Manual Gateway Instruction Manual Introduction Table of Contents This manual describes how to install, test and service a Gateway. The Gateway is 1  Introduction 4  part of the Level Monitoring System, which includes the Gateway, up to 40 Level Monitors (hereafter referred to as Monitors), and a Data Center that provides the 2 ...
  • Page 3 Gateway Instruction Manual Gateway Instruction Manual  Certifications Strong electromagnetic fields such as those found in close proximity to power lines, large electric motors, generators, electric fences and This equipment contains a radio module and a cellular modem that comply with transmitter antennas may interfere with the radio signal received by the Part 15 of the FCC Rules.
  • Page 4 Gateway Instruction Manual Gateway Instruction Manual Wiring Warning: Remove all power to the board before opening the enclosure for service. Electric shock or deathcouldoccur. Avertissement: Enlevez tout le pouvoir de la planche avant d'ouvrir la clôture pour le service. Le décharge électrique ou la mort pourraient se produire.
  • Page 5 Gateway Instruction Manual Gateway Instruction Manual Caution: Risk of Explosion if battery is replaced by The Data Center light indicates Data Center communication status. The Data an incorrect type.Dispose of used batteries Center light blinks approximately once per second any time Gateway is powered.
  • Page 6 Windows 7 which is available at reboot Safely reboot the gateway www.centeron.net/downloads/setup.bat. If your driver installation fails when you getgwinfo Get information regarding this gateway unit connect the USB from the Gateway to your computer, then download and run the Example: setup.bat patch.
  • Page 7 Gateway Instruction Manual Gateway Instruction Manual 1= Enable Static IP Addressing The new DHCP connection should be established in less than a minute and can be confirmed by observing the Data Center light as it transitions from red to yellow and 0=Enable DHCP IP addressing then to flashing green as it waits for communication from the Data Center.