Summary of Contents for Abundant Flow Water Systems ROFK5
- Page 1 Reverse Osmosis System Installation & Service Manual 2261 Schoenchen Rd. Pfeifer, KS 67660 www.afwfilters.com 785-735-9769...
- Page 2 System Filter Set 5-stage Filters: Every 6 months for most homes, at least once a year ROFK5 6-stage w/ UV UV Bulb: Every 12 months (on systems equipped with a UV light) 6-stage w/ pH ROFK6...
- Page 3 Table of Contents IMPORTANT INFORMATION ........................II ..........................AINTENANCE TABLE OF CONTENTS .......................... III PRE-INSTALLATION PREPARATION ....................1 ................ 1 RIEF ECHNICAL UMMARY OF THE ILTRATION ROCESS : ......................1 ATER URIFICATION UMMARY : ......................1 YSTEM AINTENANCE UMMARY ........................ 2 INSTALLATION HECK ..........................
- Page 4 NOTES...
-
Page 5: Pre-Installation Preparation
©Abundant Flow Water Systems, Inc. 2009 Revised 9/09 Pre-installation Preparation IMPORTANT: Read through the entire instruction manual before beginning installation. Abundant Flow Water is not responsible for any damage, injury, or monetary loss incurred from failure to read and follow instructions. -
Page 6: Check List
©Abundant Flow Water Systems, Inc. 2009 Revised 9/09 Pre-installation Check List 1. Read through and familiarize yourself with these instructions and the installation process. This will ensure you have the proper tools, parts, and abilities to install the system before beginning, rather than having to stop halfway through because you are missing something or are unable to do something. - Page 7 ©Abundant Flow Water Systems, Inc. 2009 Revised 9/09 Slip Joint Adapter - Metal fitting with male & female ends, smaller female threads on one side for attaching the angle ball valve. Fits most standard faucet shanks for easy feed water installation.
- Page 8 ©Abundant Flow Water Systems, Inc. 2009 Revised 9/09 3. Continue to enlarge the pilot hole with larger metal cutting bits until the hole is 1/2" 4. Clean up any sharp edges Note: Air gap faucets are required by some local plumbing codes.
- Page 9 ©Abundant Flow Water Systems, Inc. 2009 Revised 9/09 Feed Water Installation: 1. The feed water assembly consists of a 1/2" slip joint adapter with 2 washers and an angle ball valve. Locate these parts in the installation kit. If space permits, the angle valve should be installed into the slip joint adapter before connecting the assembly to the feed water line (Note: Teflon tape must be used on angle valve to prevent leaks).
- Page 10 ©Abundant Flow Water Systems, Inc. 2009 Revised 9/09 2. The hole position on the pipe should be marked and drilled with a 1/4" bit. If using a horizontal pipe, ensure the hole is made on the top of the pipe, so that standing water in the pipe will not leak into the drain saddle.
- Page 11 ©Abundant Flow Water Systems, Inc. 2009 Revised 9/09 Example of Connected System (System may differ from the one shown)
-
Page 12: System Start Up
©Abundant Flow Water Systems, Inc. 2009 Revised 9/09 System Start Up: After all the connections have been made it is time to prepare the system for use. If the system has a UV filter, plug the wire coming from the UV filter into the transformer and plug the transformer into any standard 110v outlet. -
Page 13: System Maintenance
©Abundant Flow Water Systems, Inc. 2009 Revised 9/09 System Maintenance Filters: Filters need changed regularly to ensure Filter Set Filters Included System protection of the membrane and high Sediment, GAC, Carbon Block, 5-stage purity water production. ROFK5 Post Filter The replacement filter set you need 6-stage w/ UV depends on the optional filters you have. -
Page 14: M Embrane
©Abundant Flow Water Systems, Inc. 2009 Revised 9/09 7. Once the pre-filters (the filters in the housings) have been changed, it is time to change the inline filter(s) (the post filter, as well as the DI & pH/Mineral filter if the system has them.) To replace them,... -
Page 15: O- Rings
©Abundant Flow Water Systems, Inc. 2009 Revised 9/09 5. Disconnect the tube feeding the membrane (the tube going to the single fitting on the membrane housing cap). If unsure how to disconnect the quick connect fittings, refer to the section on quick connect near the beginning of the manual. - Page 16 ©Abundant Flow Water Systems, Inc. 2009 Revised 9/09 system and damage your membrane, so even if you have a UV filter it is recommended that you use this procedure. We recommend sanitizing during a filter change, that way the old filters can be removed and thrown away, the system can be sanitized and new filters put in.
-
Page 17: Guide
©Abundant Flow Water Systems, Inc. 2009 Revised 9/09 Troubleshooting Note: To remove tubing from quick connect fittings, hold in on the small collet ring at the end of the fitting, push this ring in towards the fitting while gently pulling out on the tubing. This releases the tubing... -
Page 18: Flow
©Abundant Flow Water Systems, Inc. 2009 Revised 9/09 Tracing Water Flow Note: Tank valve needs to be shut off unless otherwise indicated. When tracing water flow, shut feed water valve off and, remove line to be checked from fitting. Turn feed water valve back on, ensuring it is fully open before checking flow. - Page 19 ©Abundant Flow Water Systems, Inc. 2009 Revised 9/09 Connection Diagram Arrows indicate flow direction (Not to scale) [15]...
-
Page 20: Reverse Osmosis System Limited Warranty
Reverse Osmosis System Limited Warranty Abundant Flow Water Systems, Inc. What Does This Warranty Cover? This warranty covers manufacturer defects on your Reverse Osmosis system (System). This includes filter housings, membrane housings, brackets, membranes, fittings, transformers, clips, check valves, flow restrictors, ball valves, storage tanks, faucets, adapters, drain valves, filter housing wrenches, tubing, and accessories included in your original order.