Advertisement
Quick Links
Advertisement
Summary of Contents for Voice Active VoiceAmp II
-
Page 1: User Guide
VOICE active VoiceAmp II User Guide Part Number VAHE18 Issue 1.0... - Page 2 Introduction Congratulations on purchasing the Voice Active VoiceAmp II - multipurpose headset adaptor. This unit is supplied to make your office telephone “headset compatible”. Please read the following instructions carefully to successfully set up and operate your headset and adaptor.
- Page 3 Headset active/busy indicator Mute indicator Mute switch Handset/Headset selection switch Headset jack socket Headset compatibility switch Volume control Additional control switches Compatibility switch compartment Pack Contents VoiceAmp II Headset Adaptor Standard Stub Cable 2 x AA Batteries (Alkaline) Instruction booklet...
- Page 4 Installation Unclip the battery compartment cover (5) and install 2 x AA batteries (supplied) and replace the cover. Plug the stub cable (supplied) into the telephone jack socket (3). Unplug the coiled handset cord from the base of your telephone and plug in the free end of the stub cable instead.
- Page 5 Operation Lift the handset off the cradle, you may be able to program a key to activate the hook switch instead. Check with the instruction manual for your system. You should hear dial tone in the handset, press the handset/headset switch to change over to headset mode.
-
Page 6: Troubleshooting
Troubleshooting Callers can’t hear me or I can’t hear my callers Check all cables are connected correctly. Check that the compatibility switches are correctly configured (factory setting is 1E). Check the handset/headset button (9). Push the button in for headset use and push again to release for handset use. - Page 7 This product is covered by a two year manufacturers warranty which covers electronic/electrical failure only. Voice Active endeavours to evaluate the warranty claim on the day of receipt and to return any repaired or replaced goods for delivery on the next working day wherever possible.