Advertisement
Quick Links
Battery replacement:
FEA
Remove the four screws on the bottom cover to access the battery
compartment. If storing the unit for long periods of time the battery
DUAL BAND
should be removed to prevent corrosion of the battery snap. Be sure
to place the battery wires along the side of the battery in the battery
COMPRESSOR LIMITER
pocket and use care while replacing the bottom cover.
Warranty:
The FEA Dual Band Compressor Limiter is fully covered for a period
of 5 (five) years and the foot switches are covered for 1 (one) year
against defects in material and workmanship. Abuse and neglect are
not covered under the warranty. Any modifications or repairs not
authorized by FEA voids all warranties. The customer will be
responsible for shipping cost to and from FEA Labs for repairs.
Contact me before attempting to ship a unit for repair at:
info@fealabs.com.
All repairs made outside of the warranty period will be very
reasonable (usually only the cost of the parts)... your satisfaction is
priority one.
Contact FEA Labs at:
www.fealabs.com
info@fealabs.com
www.fealabs.com
REV 4.1
Advertisement
Summary of Contents for FEA DB-CL
-
Page 1: Battery Replacement
Warranty: The FEA Dual Band Compressor Limiter is fully covered for a period of 5 (five) years and the foot switches are covered for 1 (one) year against defects in material and workmanship. Abuse and neglect are not covered under the warranty. -
Page 2: Technical Specifications
Silonex™) uses a combination formula for the photocell to compression and output gains set overcome these limitations in the AOI that is used in the FEA to maximum. **This is the absolute Dual Band Compressor Limiter or DB-CL. This very same AOI worst case noise scenario.**... - Page 3 Min-Max and Limit RATIOS: Threshold set at –25dB for all tests. The dual rail power supply in the DB-CL is built on its own discrete circuit board to physically separate it from the audio circuits. The power supply is over filtered two times to assure exceptionally clean power for the signal circuitry.
- Page 4 INPUT settings and hard-knee at maximum RATIO settings. The jack. The “switch on” sensing method used in the FEA COMP LED indicates when the THRESHOLD has been Dual-Band Compressor-Limiter keeps nearly all of the reached.
Need help?
Do you have a question about the DB-CL and is the answer not in the manual?
Questions and answers