1. Manuals
  2. Brands
  3. Timberline Tool Manuals
  4. Power Tool
  5. TRTW1
  6. Instruction manual

Timberline Tool TRTW1 Instruction Manual

Tracer-lock system
Hide thumbs

Advertisement

Table of Contents

®
Tracer-Lock System
Model TRTW1

Instruction Manual

For your personal safety READ and UNDERSTAND
instructions before using tools.
SAVE these instructions for future reference.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TRTW1 and is the answer not in the manual?

Questions and answers

Related Manuals for Timberline Tool TRTW1

Summary of Contents for Timberline Tool TRTW1

  • Page 1: Instruction Manual

    ® Tracer-Lock System Model TRTW1 Instruction Manual For your personal safety READ and UNDERSTAND instructions before using tools. SAVE these instructions for future reference.

  • Page 2: General Safety Rules

    Please read the following suggested procedure for using Timberline Tracer-Lock tools. GENERAL SAFETY RULES For all Tracer-Lock Tools READ and UNDERSTAND all instructions. Failure to follow all instructions listed below may result in serious personal injury and/or damage to the tool. © 2008 Timberline Tool All Rights Reserved.

  • Page 3: Safety Instructions

    Accidents may be caused by improperly main- tained tools. Failure to use the TRTW1 in the manner specified in this manual may result in injury and/or permanent damage to the tool. Tool Service Safety Tool service must only be performed by qualified repair personnel.
  • Page 4 A3 – Bottom Plate • A4 – Pivot Bolt • A5 – Plate Bolt (Quantity 2) Familiarize yourself with all parts, names, and numbers. Refer to this diagram for the assembly and operation procedures that follow. © 2008 Timberline Tool All Rights Reserved.

  • Page 5: Operating Procedure

    TIMBERLINE TRTW1 OPERATING PROCEDURE Open the tool and plates as shown prior to in- serting the top and bottom connectors (Fig. 1). Fig. 1 Identify the top connector (Fig. 2). Fig. 2 Identify the bottom connector half (Fig. 3). Note the hole location on the bottom con- nector where the branch tracer wire will be inserted.
  • Page 6 The dielectric gel should exude out of the connector and surround the wires (Fig. 8). Open the tool and the completed connector will release from its friction fit (Fig. 9). Fig. 7 Fig. 9 Fig. 8 © 2008 Timberline Tool All Rights Reserved.

  • Page 7: Warranty Policy

    800.735.6845 to obtain return authorization for repair. If inspection shows the trouble is caused by defective workmanship or material, Timberline Tool will repair or, at our option, replace the product without charge.
  • Page 8 (406)755-4258 (406)257-2711 www.timberlinetool.com 90 Conestoga Ct. Kalispell, MT 59901 USA © Timberline Tool all Rights Reserved. Revised 5.16.11...

Table of Contents